Filename: tfs 590.doc Version 1.3 VI TELEFILTER 15.07.2005 Filter specification TFS 590 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 170 Ω || -5,6 pF 226 Ω || -4,7 pF Characteristics Remark: The reference level for the relative attenuation arel of the TFS 590 is the minimum of the pass band attenuation. This value is defined as the insertion loss ae. The nominal frequency fN is fixed at 590 MHz without any tolerance. The values of relative attenuation arel are guaranteed for the whole operating temperature range. The frequency shift of the filter in the operating temperature range is included in the production tolerance scheme. Data typ. Value Insertion loss within PB (reference level) ae 6,0 Nominal frequency fN - Centre frequency fC 590,0 Passband PB dB fN + 20,0 1,4 7,5 dB 590,0 MHz 195 kHz MHz dB max. 634 kHz min. 45 45 dB dB min. min. ± 1,0 dB MHz ... MHz ... 390 kHz arel Relative attenuation fN - max. BW Bandwidth 1 dB fN 0,4 Pass band ripple tolerance / limit fN fN + 1,4 20,0 Operating temperature range MHz MHz OTR Storage temperature range Frequency inversion temperature Temperature coefficient of frequency TCf ** 40,0 40,0 - - 25 °C ... + 75 °C - - 40 °C ... + 85 °C 18 °C -0,035 ppm/K 2 dB dB - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆ f(Hz) =TCf(ppm/K2) x(T-T0)2 x fTo (MHz) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 590.doc Version 1.3 VI TELEFILTER 15.07.2005 Filter specification TFS 590 2/5 0 3.4 -1 3.1 -12 -2 2.8 -18 -3 2.5 -24 -4 2.2 -5 1.9 -6 1.6 -42 -7 1.3 -48 -8 1 -54 -9 0.7 -30 -36 -60 570 574 578 582 586 590 594 frequency in MHz 598 602 606 -10 589.25 610 589.4 589.55 589.7 589.85 590 590.15 frequency in MHz 590.3 590.45 590.6 delay in µs 0 -6 magnitude in dB magnitude in dB Filter characteristic 0.4 590.75 Construction and pin connection (All dimensions in mm) S 590 ● T29 Date code 1 2 3 4 5 6 7 8 9 10 Ground Ground Ground Output Output Ground Ground Ground Input Input RF Return Date code: T U V ... Year + week 2005 2006 2007 50 Ohm Test circuit 9 L1 L2 10 4 SAW 5 L5 L3 L4 1, 2, 3, 6, 7, 8 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 590.doc Version 1.3 VI TELEFILTER 15.07.2005 Filter specification TFS 590 3/5 Stability characteristics After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,50 ± 0,1 Bo : 7,50 ± 0,1 Ct : 13,5 ± 0,1 t P1 Date Code Po P2 W G Ct Bo F G E Do Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 +2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0 +0,5/-0,2 C A N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 590.doc Version 1.3 VI TELEFILTER 15.07.2005 Filter specification TFS 590 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 590.doc VI TELEFILTER Version 1.3 Filter specification 15.07.2005 TFS 590 5/5 History Version Reason of Changes Name Date 1.0 Generation of development specification Strehl 20.04.2005 1.1 Correct operating temperature range Strehl 09.05.2005 1.2 pinning changed Î input single ended / output balanced driven Pfeiffer 13.05.2005 1.3 - terminating impedance, typical values and filter characteristic added - matching configuration modified - insertion loss: limit changed Pfeiffer 15.07.2005 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.