TFS70AC

Filename: tfs 70ac.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
TFS 70AC
1/5
Measurement condition
25 °C
Ambient temperature TA:
Input power level:
0 dBm
Terminating impedances at fc *):
Input:
484 Ω || -22,0 pF
Output:
127 Ω || -33,4 pF
Characteristics
Remark: Reference level for the relative attenuation arel of the TFS 70AC is the minimum of the pass band attenuation amin. The minimum of the pass
band attenuation amin is defined as the insertion loss ae The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3
dB filter attenuation level relative to the insertion loss ae. The temperature coefficient of frequency Tcf is valid for both the reference frequency fc and the
frequency response of the filter in the operating temperature range.
Data
typ. value
ae
Insertion loss
7,5
tolerance / limit
dB
max.
9,5
dB
MHz
70,0
± 0,1
MHz
MHz
dB
fc ±
max.
2,8
1
MHz
dB
dB
dB
max.
max.
1
3
dB
dB
dB
min.
40
dB
max. 120
ns
(reference level)
Centre frequency at ambient temperature
fc
Pass band
Amplitude ripple within PB
PB
Relative attenuation
arel
fc
fc
±
3,1
.........
MHz .........
fc ±
fc ±
fc
±
5,975 MHz .........
fc ±
3,1
3,5
20
Group delay at fc
Group delay ripple in PB
Phase linearity in fc ± 2,45 MHz
MHz
MHz
MHz
70
fc ± 3,6
0.3
0,5
2
50
1,21
68
4
µs
ns
deg p-p
max.8
deg p-p
Operating temperature range
-
- 30 °C ... + 80
°C
Storage temperature range
-
- 40 °C ... + 85
°C
Temperature coefficient of frequency TCf**
- 94
ppm / K
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values
only. Should there be additional questions, do not hesitate to ask for an application note or contact our design team.
**) ∆fc(Hz) = Tcf(ppm/K) x (T - TA) x fN (MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70ac.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
TFS 70AC
2/5
0
2.115
-1
2.01
-16
-2
1.905
-24
-3
1.8
-32
-4
1.695
-5
1.59
-6
1.485
-56
-7
1.38
-64
-8
1.275
-72
-9
1.17
-40
-48
-80
50
54
58
62
66
70
frequency in MHz
74
78
82
86
-10
66
90
66.8
67.6
68.4
69.2
70
70.8
frequency in MHz
71.6
72.4
73.2
delay in µs
0
-8
magnitude in dB
magnitude in dB
Filter characteristic
1.065
74
Construction and pin connection
(All dimensions in mm)
TFS 70AC
●
U09
6,8Max.
13,6Max.
2,54 ±0,15
1,5
2,54 ±0,15
1 2 3 4
2,0Max.
1
12
5
11
6
Date code
10 9 8 7
1
2
3
4
5
6
7
8
9
10
11
12
Ground
Ground
Ground
Ground
Output
Output RF Return
Ground
Ground
Ground
Ground
Input
Input RF Return
Date code:
U
V
W
...
Year + week
2006
2007
2008
0,1
0,8
50 Ohm Test circuit
L1
11
12
5
SAW
L2
6
C2
C1
1, 2, 3, 4, 7, 8, 9, 10
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70ac.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
TFS 70AC
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
1700
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
Tape (all dimensions in mm)
W
: 24,00 +0,30/-0,10
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,10
F
: 11,50 ± 0,10
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 12,00 ± 0,1
D1(min)
: 1,50
Ao
: 7,10 ± 0,10
Bo
: 13,90 ± 0,10
Ct
: 21,5 ± 0,1
P1
t
Po
P2
G
Ct
Bo
F
G
E
Do
PIN Marker
W
Tape & Reel:
Ko
Date Code
Typ
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 24,4
W2(max) : 30,4
N(min)
: 60
C
: 13,0
C
A
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70ac.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
TFS 70AC
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70ac.doc
VI TELEFILTER
Version 1.3
Filter specification
03.03.2006
TFS 70AC
5/5
History
Version
Reason of Changes
Name
Date
1.0
- generate development specification
Pfeiffer
14.05.2003
1.1
- fN changed to fc generate development specification
- remove nominal frequency fN
Chilla
08.09.2003
1.2
- changed to filter specitication
- terminating impedances added
- typical values added
- group delay at fN changed to 1,21 µs typical value
- matching network added
Chilla
24.11.2003
1.3
- filter characteristics added
- test circuit updated
- RoHS compliant added
- air reflow temperature conditions updated
Chilla
03.03.2006
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.