VECTRON TFS140X_06

Filename: tfs 140x.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
TFS 140X
1/5
Measurement condition
Ambient temperature:
Input power level:
Source and load impedance:
Terminating impedances *
Input:
Output:
25
0±2
50 Ω
°C
dBm
99 Ω || - 28.3 pF
103 Ω || - 27.2 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of TFS140X is the minimum of the pass band attenuation amin. This value is defined as the insertion
loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 20 dB filter attenuation level relative to the insertion
loss ae. The frequency shift of the filter in the operating temperature range is not included in the production tolerance scheme
Data
typ. value
Insertion loss
ae = amin
Nominal frequency
fN
9
140
dB
limit
max.
12
140,0
MHz
Centre frequency fc (at ambient temperature)
139,60 ... 140,40
Pass band
fN
PB
± 7,1
dB
MHz
MHz
MHz
Amplitude ripple (peak to adjacent valley)
within fN ± 7,2 MHz
0.2
Bandwidth
1
dB
3
dB
17,6
18,5
MHz
MHz
min.
min.
17
17,75
MHz
MHz
35
40
21,8
24,8
MHz
MHz
max.
max.
24
48
MHz
MHz
dB
dB
max.
max.
1
3
40
50
6
dB
dB
deg
min.
min.
max.
35
40
10
dB
dB
deg p-p
44
ns
max.
60
ns
777
ns
max.
825
ns
max.
+ 10
dB
dB
Relative attenuation
fN ...
fN ±
fN ± 8,5 MHz ... fN ±
max.
dB
arel
fN ± 12
MHz ... fN ±
MHz ... fN ±
fN ± 24
Phase variation within PB
8,5 MHz
8,875 MHz
24
40
0,5
1,5
MHz
MHz
Group delay ripple within PB
Absolute group delay within PB
Input power level
dBm
- 40 °C ... + 85 °C
Storage temperature range
Temperature coefficient of frequency
dB
dB
- 40 °C ... + 85 °C
Operable temperature range
*)
1
TCf
-87
ppm/K
The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
reference values only. Should there be additional questions, do not hesitate to ask for an application note or contact our design team.
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140x.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
TFS 140X
2/5
0
1.182
-1
1.134
-14
-2
1.086
-21
-3
1.038
-28
-4
0.99
-5
0.942
-6
0.894
-49
-7
0.846
-56
-8
0.798
-63
-9
0.75
-35
-42
-70
100.5
108.5
116.5
124.5
132.5
140.5
148.5
frequency in MHz
156.5
164.5
172.5
-10
130.5
180.5
132.5
134.5
136.5
138.5
140.5
142.5
frequency in MHz
144.5
146.5
148.5
delay in µs
0
-7
magnitude in dB
magnitude in dB
Filter characteristic
0.702
150.5
Construction and pin connection
(All dimensions in mm)
TFS 140X
●
U09
6,8Max.
13,6Max.
2,54 ±0,15
1,5
2,54 ±0,15
1 2 3 4
2,0Max.
1
12
5
11
6
Date code
10 9 8 7
1
2
3
4
5
6
7
8
9
10
11
12
Ground
Ground
Ground
Ground
Output
Output RF Return
Ground
Ground
Ground
Ground
Input
Input RF Return
Date code:
U
V
W
...
Year + week
2006
2007
2008
0,1
0,8
50 Ohm Test circuit
L1
11
12
5
SAW
C1
L2
6
C2
1, 2, 3, 4, 7, 8, 9, 10
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140x.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
TFS 140X
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
1700
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
P1
Tape (all dimensions in mm)
W
: 24,00 +0,30/-0,10
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,10
F
: 11,50 ± 0,10
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 12,00 ± 0,1
D1(min)
: 1,50
Ao
: 7,10 ± 0,10
Bo
: 13,90 ± 0,10
Ct
: 21,5 ± 0,1
t
Po
P2
W
G
Ct
Bo
F
G
E
Do
PIN Marker
Ko
Date Code
Typ
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 24,4 +2/-0
W2(max) : 30,4
N(min)
: 60
C
: 13,0 +0,5/-0,2
C
A
N
W 1
The minimum bending radius is 45 mm.
Air reflow temperature conditions
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140x.doc
Version 1.3
VI TELEFILTER
03.03.2006
Filter specification
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
TFS 140X
4/5
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140x.doc
VI TELEFILTER
Version 1.3
Filter specification
03.03.2006
TFS 140X
5/5
History
Version
Reason of Changes
Name
Date
1.0
generation of specification according to customer requirements
E. Chilla
28.04.2003
1.1
group delay ripple changed
absolute group delay added
E. Chilla
21.04.2003
1.2
changed to filter specification
terminating impedances added
typical values added
pass band added
bandwidth for 1 dB, 3 dB, 35 dB changed
relative attenuation changed
E. Chilla
24.11.2003
1.3
filter characteristics added
RoHS compliant added
air reflow temperature conditions updated
E. Chilla
03.03.2006
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.