TFS70BE

Filename: TFS70BE.doc
Version 1.2
Vectron International
26.11.2012
Filter specification
TFS 70BE
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
0
°C
dBm
1.6 Ω || -7.7 pF
1.75 Ω || -7.5 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 70BE is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 70.0 MHz without any tolerance. The given values for both the
relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. value
Insertion loss
(reference level)
ae
13.3
Nominal frequency
fN
-
Centre frequency at ambient temperature
fC
70.0
PB
Pass band
dB
tolerance / limit
max.
MHz
dB
70.0
MHz
fN
-
15.0
±
0.5
MHz
Pass band variation
0.4
dB
max.
0.8
dB
Amplitude ripple in any 112.5 kHz segment in PB
0.15
dB
max.
0.5
dB
0.4
dB
max.
0.8
dB
arel
Relative attenuation
fN
… fN
±
0.5
MHz
fN
fN
±
±
1.1
1.5
MHz … fN
MHz … fN
±
±
1.5
3.0
MHz
MHz
42
42
dB
dB
min.
min.
37
40
dB
dB
fN
+
0.3
3.0
MHz … fN
MHz … fN
+
3.0
1.0
MHz
GHz
53
52
dB
dB
min.
min.
50
50
dB
dB
µs
max.
4
µs
ns
max.
120
ns
deg
max.
5
at fN
Group delay
Group delay ripple within PB
2.35
70
(in any 112.5 KHz segment in PB)
Phase linearity within PB
p-p
2.0
deg
(in any 112.5 KHz segment in PB)
Input power level
Operating temperature range
OTR
Storage temperature range
Frequency inversion temperature
Temperature coefficient of frequency
TCf ***
-
max.
23 ** dBm
-
- 40 °C ... + 70 °C
-
- 40 °C ... +100 °C
25
°C
-
- 0.036
ppm/K2
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values
only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) This power level is only allowed for short term operation (10% of the life time), the max. input power for continuous operation is max.15dBm only
***) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz)
Generated:
Checked / Approved:
Vectron International GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International GmbH reserves the right to make changes to the product(s) and/or information contained herein without notice.
No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or
information.
Filename: TFS70BE.doc
Version 1.2
Vectron International
26.11.2012
Filter specification
TFS 70BE
2/5
0
3.62
-1
3.47
-16
-2
3.32
-24
-3
3.17
-32
-4
3.02
-5
2.87
-6
2.72
-56
-7
2.57
-64
-8
2.42
-72
-9
2.27
-40
-48
-80
60
62
64
66
68
70
72
frequency in MHz
74
76
78
-10
69
80
69.2
69.4
69.6
69.8
70
70.2
frequency in MHz
70.4
70.6
70.8
delay in µs
0
-8
magnitude in dB
magnitude in dB
Filter characteristic
2.12
71
Construction and pin connection
(All dimensions in mm)
10
+0,20
TFS 70BE
●
C21
1
+0,20
5
19 -0,10
2,0 Max. 6,50 - 0,10
6
1
2
3
4
5
6
7
8
9
10
Date code
Input
Ground
Ground
Ground
Output
Output
Ground
Ground
Ground
Input
1,02
1
2,31
Date code:
C
D
E
...
Year + week
2012
2013
2014
1,91
7,62
50 Ohm Test circuit
1
5
L1
C1
L2
10
SAW
L4
L6
6
L5
2, 3, 4, 7, 8, 9
Vectron International GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International GmbH reserves the right to make changes to the product(s) and/or information contained herein without notice.
No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or
information.
Filename: TFS70BE.doc
Version 1.2
Vectron International
26.11.2012
Filter specification
TFS 70BE
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or g respectively, 1 octave per min, 10 cycles per plane, 3 planes;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
5. ESD
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: three times max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
ANSI/ESD S20.20-1999, class 1A for HBM
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
Pull Off Direc tion
Ko
Date Cod e
P1
P2
Ao
Bo
Po
Ct
So
Do
E
t
W
Tape (all dimensions in mm)
W
:32,00 ± 0,3
Po
:4,00
± 0,1
Do
:1,50
+0,1/-0
E
:1,75
± 0,1
F
:14,20 ± 0,1
P2
:2,00
± 0,1
P1
:12,00 ± 0,1
D1(min)
:2,00
Ao
:7,10
± 0,1
Bo
:19,60 ± 0,1
So
:28,40 ± 0,1
Ct
:25,5
± 0,1
2000
min. 300 mm
min. 500 mm
min. 300 mm
Typ e
PIN Marker
D1
W2
Reel (all dimensions in mm)
A
: 330
W1
:32,4
+2/-0
W2(max) :38,4
N(min)
: 100
C
:13,0
+0,5/-0,2
C
A
N
W1
The minimum bending radius is 45 mm.
Vectron International GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International GmbH reserves the right to make changes to the product(s) and/or information contained herein without notice.
No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or
information.
Filename: TFS70BE.doc
Version 1.2
Vectron International
26.11.2012
Filter specification
TFS 70BE
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Vectron International GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International GmbH reserves the right to make changes to the product(s) and/or information contained herein without notice.
No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or
information.
Filename: TFS70BE.doc
Vectron International
Version 1.2
Filter specification
26.11.2012
TFS 70BE
5/5
History
Version
Reason of Changes
Name
Date
1.0
- Generation of development specification
Strehl
07.11.2007
1.1
- Correct group delay ripple within PB
- Correct pass band ripple
- Correct phase linearity within PB
- Add terminating impedances
- Add typical values
- Add filter characteristics
- Add matching circuit
- Generation of filter specification
Strehl
20.05.2008
1.2
- Remove previous screening requirements, (now with std screening only).
TCUK
26.11.2012
Vectron International GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International GmbH reserves the right to make changes to the product(s) and/or information contained herein without notice.
No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or
information.