TFS35A - Vectron International

TFS35A.doc
version 1.4
VI TELEFILTER
Filter specification
06.04.2003
TFS 35A
1/5
1. Measurement condition :
Ambient temperature TA:
Input power level:
Terminating impedances in fc * ):
Source impedance .
Load impedance .
25 °C
0 dBm
for input:
for output:
50 Ω.
50 Ω.
310. Ω ⎟⎢ -25,7 pF.
690 Ω ⎟⎢ -10,1 pF.
2. Characteristics :
Remark: Reference level for the relative attenuation arel of the TFS 35A is the minimum of the pass band attenuation amin. The minimum of the
pass band attenuation amin is defined as the insertion loss ae. The reference frequency fc is the arithmetic mean value of the upper and lower
frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. . The nominal frequency fN is fixed at 35,42 MHz without tolerance.
All specified values are guarantied in operating temperature range.
Measurement of filter response will be done at temperatures of –40°C , 25°C and 85°C for each part.
Data
typ. value
tolerance / limit
max.
Insertion loss (Reference level)
ae
14,8
Nominal frequency
fN
-
Centre frequency
fc at ambient temperature (fCTA)
Pass band :
Bandwidth :
1 dB
3 dB
MHz
dB
MHz
fC ... fC ± 0,80 MHz
0,6
dB
max.
1,6 dB
2,01
2,44
MHz
MHz
min.
1,7 MHz
-
3,32
MHz
max.
3,74 MHz
dB
max.
1,6 dB
dB
dB
dB
dB
dB
dB
dB
dB
min.
min.
min.
min.
min.
min.
min.
BW
21 dB
Relative attenuation in O.T.R. :
34,62 MHz ... 36,22 MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
17
35,42
PB
Amplitude ripple in PB (p-p) :
0,1
7
28
31
37,34
39,84
62,42
72,42
35,42
dB
... 7
... 28
... 31
... 33,5
... 39,84
... 62,42
... 72,42
... 110,42
arel
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
Group delay ( mean value in PB ):
0,8
55...27
55...50
35
40...30
27...42
45...60
36
70...80
µs
max.
Group delay ripple in PB (p-p) :
200
ns
max.
Deviation from linear phase in PB (p-p) :
±2
degree
Triple transit attenuation compared to main signal
35
dB
Crosstalk attenuation compared to main signal
50
dB
Temperature coefficient of frequency ( Tcf )
Frequency deviation of fc over temperature
1,4
- 20
35
30
21
21
35
30
40
dB
dB
dB
dB
dB
dB
dB
1,7 µs
300
ns
-
ppm/K
-
∆fc(Hz) = Tcf(ppm/K) x (T - TA) x fCTA (MHz)
-
Operating temperature range ( O.T.R. )
-
- 40 °C ... + 85 °C
Storage temperature range
-
- 55 °C ... + 125 °C
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
Generated:
Checked / approved:
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of
their use or application. No rights under any patent accompany the sale of any such product(s) or information.
TFS35A.doc
version 1.4
VI TELEFILTER
Filter specification
3. Package and pin connection :
TFS 35A
06.04.2003
2/5
(All dimensions in mm)
13,6 Max.
1
35A
R19
6,8 Max.
TFS
001
date -code:
N
P
R
year + week
2001
2002
2003
...
...
date-code
Serial number
Unbalanced :
2
1
2,54 ± 0,15
2,0 Max.
2,54 ± 0,15
1,5
4
3
Pin
Pin
Pin
Pin
Pin
12
Pin
Pin
Pin
Pin
Pin
6
9
10
8
Input
Input RF Return
Output
Output RF Return
Package Ground
Balanced :
5
11
11
12
5
6
1-4, 7-10
11
12
5
6
1-4, 7-10
Input
Input
Output
Output
Package Ground
7
0,8
0,1
4.1 50 Ω matching network ( for details refer to application note ):
1
Scheme 1
2
3
4
12
5
L2
C1
50 Ω
50 Ω
C2
6
11
L1
10
9
8
7
4.2 Matching network for 500 Ω x 1000 Ω ( for details refer to application note ) :
Scheme 2
500 Ω
1
C1
2
3
4
12
C3
5
L2
1000 Ω
L1
6
11
C2
10
9
8
C4
7
For final test we use scheme 1.
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of
their use or application. No rights under any patent accompany the sale of any such product(s) or information.
TFS35A.doc
version 1.4
VI TELEFILTER
Filter specification
06.04.2003
TFS 35A
3/5
5.1. 100% Screening Tests :
After the following tests the filter shall meet the whole specification. Electrical tests after test 4, test 5 and 7.
1. Internal Visual Inspection: according to MIL-STD-883 method 2017
2. Stabilization Bake:
16 hrs at 125°C under Vacuum according to MIL-STD-883 Method 1008 Condition B
3. Temperature Cycling:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N equivalent MIL-STD-202 Method 107
4. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
5. Burn-in:
160hrs at 125°C ( no input power ) according to MIL-STD-883 Method 1015
6. Seal test:
gross leak bubble test – Fluorocarbon liquid at 125°C ± 5°C
MIL-STD-202 Method 112 Condition D
Fine leak spot test – Helium detector according to MIL-STD-202 Method 112 Condition C
7. External Visual Inspection: according to MIL-STD-883 method 2009
5.2. Qualification Tests :
1. Resistance to
solder heat (reflow):
2. Vibration:
3. Life test:
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 – 6
storage of 2 pcs for 1000 hrs at 125°C ( no input power ) MIL-STD-883 Method 1005. The test will
be done using samples which were handled according to point 5.1.
6. Packing :
Tape & Reel:
DIN IEC 286 - 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
Trailer
1700
min 300 mm
min 500 mm
min 300 mm
EMBOSSED CARRIER TAPE
Tape (all dimensions in mm)
Do
W
Po
Do
E
F
G (min)
P2
P1
D1(min)
Ao
Bo
CT
:
:
:
:
:
:
:
:
:
:
:
:
24± 0,3
4
± 0,1
1,5
+ 0,1
1,75 ± 0,1
11,5 ± 0,1
0,6
2
± 0,1
12
± 0,1
1,5
7,1
± 0,2
13,9 ± 0,2
21,5 ± 0,1
Po
P
2
E
A
o
F
D
CT
B
1
W
o
G
P1
COVER TAPE
W2
Reel (all dimensions in mm):
A
W1
W2(max)
N(min)
C
:
:
:
:
:
330
24,4 + 2
30,4
60
13 +0,5/-0,2
A
C
N
W1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of
their use or application. No rights under any patent accompany the sale of any such product(s) or information.
TFS35A.doc
version 1.4
VI TELEFILTER
Filter specification
06.04.2003
TFS 35A
4/5
7. Air reflow temperature conditions :
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C - 170 °C
60 sec. - 90 sec.
main-heating periods
over 200 °C
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of
their use or application. No rights under any patent accompany the sale of any such product(s) or information.
TFS35A.doc
version 1.4
VI TELEFILTER
Filter specification
TFS 35A
06.04.2003
5/5
8. History
Version
Reason of changes
Name
Date
1.0
- Generate development specification according customer requirements.
Dunzow W.
23.01.2003
1.1
- Change storage temperature range.
- Add information about measured temperatures.
Dunzow W.
07.02.2003
1.2
- Add further test to stability characteristics.
- Add serial number to marking.
T. Kirschner
24.02.2003
1.3
- Change Paragraph 5.1 to 5.2 and wise versa
- Change the quantity mentioned in 5.2.3 from 15pcs. to 2pcs.
- Guarantee to use samples having 100% screening test for test 5.2.3
B. Küppers
27.02.2003
1.4
- Change from development specification to filter specification.
- Add termination impedances and typical values.
Dr. Wall
06.05.2003
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of
their use or application. No rights under any patent accompany the sale of any such product(s) or information.