TFS403

Filename: tfs 403.doc
Version 1.5
VI TELEFILTER
13.12.2006
Filter specification
TFS 403
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
0
°C
dBm
81 Ω || -11,5 pF
86 Ω || -12,6 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 403 is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 403,5 MHz without any tolerance. The given values for both the
relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. Value
Insertion loss
(Reference level)
ae
4,6 dB
Nominal frequency
fN
-
Pass band
PB
Amplitude ripple in PB
p-p
Relative attenuation
fN
.......
arel
fN ±
5,5
fN ±
9
fN ± 19,5
fN + 400,5
2 fN ± 3
MHz
MHz
MHz
MHz
MHz
......
.......
.......
.......
fN ±
Limit
max.
403,5 MHz
0,6 dB
1,5
MHz
-
fN ±
9
fN ± 19,5
fN ± 23,5
fN + 406,5
MHz
MHz
MHz
MHz
32
32
45
70
85
Return loss within PB
Input power level
Temperature coefficient of frequency Tcf **
5,5 dB
dB
dB
dB
dB
dB
fN ±
1,5 MHz
max.
1
max. 1
dB
min.
min.
min.
min.
min.
dB
dB
dB
dB
dB
20
25
35
20
20
14 dB
-
dB
-
max.
10
dBm
-20 ppm/K
Operating temperature range
-
- 10 °C.. + 60
°C
Storage temperature range
-
- 40 °C.. + 85
°C
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆fc(Hz) = Tcf(ppm/K) x (T - TA) x fCTA (MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 403.doc
Version 1.5
VI TELEFILTER
13.12.2006
Filter specification
TFS 403
2/5
Construction and Pin Connection
(All dimensions in mm)
+0.15
5.0 SQ -0.1
7
5
S 403
P48
1
3
Date code
Pin 1
Pin 2
Pin 3
Pin 4,8
Input
Input RF Return
Ground
Package Ground
Pin 5 Output
Pin 6 Output RF Return
Pin 7 Ground
date code:
M
N
P
...
year + week
2000
2001
2002
50 Ω matching circuit
L1
Input
50 Ohm
1
5
L3
Output
50 Ohm
SAW
L2
L4
2,3,4,6,7,8
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 403.doc
Version 1.5
VI TELEFILTER
13.12.2006
Filter specification
TFS 403
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: three times max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
DIN IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer
Tape (all dimensions in mm)
W
Po
:
:
Do
:
E
:
F
:
G (min) :
12
4
8
1,5
Ao
Bo
CT
5,3
5,3
9,5
:
:
:
2
min 300 mm
EMBOSSED CARRIER TAPE
± 0,3
± 0,1
Do
Po
P2
1,5 + 0,1
1,75 ± 0,1
5,5 ± 0,05
0,75
P2
:
P1
:
D1(min) :
3000
min 300 mm
min 500 mm
E
Ao
F
D1
CT
± 0,05
± 0,1
W
Bo
G
± 0,1
± 0,1
± 0,1
P1
COVER TAPE
W2
Reel (all d imensions in mm):
A
:
330
W1
:
12,4 + 0,2
W 2 (max) :
18,4
N (min)
:
50
C
:
13
+0,5 -0,2
A
C
N
W1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 403.doc
Version 1.5
VI TELEFILTER
13.12.2006
Filter specification
TFS 403
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 403.doc
VI TELEFILTER
Version 1.5
Filter specification
13.12.2006
TFS 403
5/5
History
Version
Reason of Changes
Name
Date
1.0
generation of “Development specification” according to customer requirements
and feasibility study
Chilla
28.05.2002
1.1
change of Tcf
add limit line 20 dB at 804-810 MHz
Chilla
22.08.2002
1.2
limit line at 2 fN ±3 MHz corrected
Chilla
26.08.2002
1.3
add typical values off terminating impedance and relative attenuation
Pfeiffer
11.09.2002
1.4
change terminating impedance and typical values of insertion loss and relative
attenuation
Pfeiffer
25.11.2002
1.5
change stability characteristics
Strehl
13.12.2006
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.