Filename: tfs 456k.doc Version 1.3 VI TELEFILTER 08.12.2006 Filter specification TFS 456K 1/5 Measurement condition Ambient temperature: Input power level: Source impedance: Load impedance: Terminating impedance: * Input: Output: 23 °C 0 dBm 200 Ω 200 Ω 248 Ω || - 5,3 pF 220 Ω || - 6,2 pF Characteristics Remark: The reference level for the relative attenuation arel of the TFS 456K is the minimum of the pass band attenuation. This value is defined as the insertion loss ae. The nominal frequency fN is fixed at 456,0 MHz without any tolerance. The values of relative attenuation arel are guaranteed for the whole operating temperature range. The frequency shift of the filter in the operating temperature range is included in the production tolerance scheme. Data typ. value ae = amin Insertion loss (reference level) 12 dB tolerance / limit max. fN Nominal frequency PB dB 456,0 MHz MHz MHz min. fN ± 5,8 0,4 dB max. 1,0 dB arel MHz MHz 0,4 0,5 dB dB max. max. 1 3 dB dB MHz MHz MHz MHz MHz MHz MHz MHz MHz MHz at fN 55 55 49 48 41 42 47 50 60 70 0,42 dB dB dB dB dB dB dB dB dB dB µs min. min. min. min. min. min. min. min. min. min. max. 30 40 40 45 40 40 45 40 40 30 3,0 Group delay ripple within PB 50 ns max. 250 ns Return loss within PB 15 dB min. 10 dB - max. 15 dBm - - 40 °C ... + 85°C Passband Pass band ripple Relative attenuation fN fN - 5,8 6,4 MHz … fN MHz … fN fN 455 MHz 200 MHz fN 96 MHz fN 47 MHz fN 33 MHz fN 13,5 MHz fN + 33 MHz fN + 47 MHz fN + 96 MHz fN + 200 MHz fN + Absolute Group Delay … … … … … … … … … … fN fN fN fN fN fN fN fN fN fN + + 5,8 6,4 + + + + + 200 96 47 33 13,5 33 47 96 200 490 Input power level Operating temperature range OTR - Storage temperature range Temperature coefficient of frequency 13,9 14,0 TCf *** -18 dB dB dB dB ** dB dB dB ** dB dB dB µs - 45 °C ... + 85°C ppm/K *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) mean value of the relative attenuation within the frequency range ***) ∆f(Hz) = TCf(ppm/K) x (T-T0) x fcat(MHz). Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 456k.doc Version 1.3 VI TELEFILTER 08.12.2006 Filter specification TFS 456K 2/5 2.29 0 2.08 -10 -2 1.87 -20 -3 1.66 -30 -4 1.45 -40 -5 1.24 -6 1.03 -7 0.82 -70 -8 0.61 -80 -9 0.4 -90 0.19 465 -100 256 -10 447 448.8 450.6 452.4 454.2 456 457.8 frequency in MHz 459.6 461.4 463.2 magnitude in dB 0 -1 delay in µs magnitude in dB Filter characteristic -50 -60 296 336 376 416 456 496 frequency in MHz 536 576 616 656 Construction and pin connection (All dimensions in mm) 7 1 +0,20 456K ● U49 SQ 3,81 - 0,10 5 3 7 5 1,78 0,1 12 0° 0,6 3 Input Input Ground Ground Output Output Ground Ground Date code: U V W ... Year + week 2006 2007 2008 1,2 Max. 2,54 1 Date code 1 2 3 4 5 6 7 8 1,78 50 Ω Test circuit L1 1:4 5 1 SAW C1 L2 C2 6 2 L2 1:4 L4 3,4,7, 8 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 456k.doc Version 1.3 VI TELEFILTER 08.12.2006 Filter specification TFS 456K 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 12,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 5,50 ± 0,05 G(min) : 0,75 P2 : 2,00 ± 0,05 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 4,30 ± 0,1 Bo : 4,30 ± 0,1 Ct : 9,5 ± 0,1 P1 t Po PIN Marker P2 W G Ct Bo F G E Do Ko Date Code Typ D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 12,4 +2/-0 W2(max) : 18,4 N(min) : 50 C : 13,0 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 456k.doc Version 1.3 VI TELEFILTER 08.12.2006 Filter specification TFS 456K 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 456k.doc VI TELEFILTER Version 1.3 Filter specification 08.12.2006 TFS 456K 5/5 History Version Reason of Changes Name Date 1.0 - generation of development specification Strehl 09.09.2004 1.1 - changed insertion loss - changed pass band - changed relative attenuation Chilla 30.11.2004 1.2 - generation of filter specification - added test circuit - added filter characteristic - reworked reflow profile Martens 01.09.2005 1.3 - change input power level and stability characteristics Strehl 08.12.2006 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.