VECTRON TFS456Q

Filename: tfs 456q.doc
Version 1.2
VI TELEFILTER
08.12.2006
Filter specification
TFS 456Q
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
0
°C
dBm
264 Ω || -6,6 pF
300 Ω || -5,7 pF
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 456Q is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fC is the arithmetic mean value of the upper and lower frequencies at the 1dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 456,0 MHz without tolerance. The given values for the relative
attenuation arel and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency fC is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fC.
Data
typ. value
ae = amin
Insertion loss
(reference level)
10
dB
Nominal frequency
fN
-
Centre frequency
fC
456
MHz
PB
14
MHz
dB
Passband
0,2
Pass band ripple
tolerance / limit
max.
13,0
dB
456,0
MHz
min.
fN ± 6,3
MHz
max.
1,0
dB
14
MHz
min.
12,6
MHz
14
MHz
max.
14,6
MHz
70
65
55
50
50
70
dB
dB
dB
dB
dB
dB
min.
min.
min.
min.
min.
min.
30
40
50
40
40
30
dB
dB
dB
dB
dB
dB
Group delay ripple within PB
40
ns
max.
200
ns
Return loss within PB
15
dB
min.
10
dB
max.
15
dBm
1 dB bandwidth
arel
Relative attenuation
fN
fN
fN
fN
fN
fN
+
+
455
200
104
47
14
200
MHz
MHz
MHz
MHz
MHz
MHz
…
…
…
…
…
…
fN
fN
fN
fN
fN
fN
+
+
200
104
47
14
200
400
MHz
MHz
MHz
MHz
MHz
MHz
-
Input power level
Operating temperature range
OTR
Storage temperature range
Temperature coefficient of frequency
TCf **
-
- 40 °C ... + 85°C
-
- 45 °C ... + 85°C
-18
ppm/k
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆fc(Hz) = TCf(ppm/K) x (T - To) x fTo (MHz).
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456q.doc
Version 1.2
VI TELEFILTER
08.12.2006
Filter specification
TFS 456Q
2/5
0
1.75
-1
1.6
-16
-2
1.45
-24
-3
1.3
-32
-4
1.15
-5
1
-6
0.85
-56
-7
0.7
-64
-8
0.55
-72
-9
0.4
-40
-48
-80
396
408
420
432
444
456
468
frequency in MHz
480
492
504
-10
447
516
448.8
450.6
452.4
454.2
456
457.8
frequency in MHz
459.6
461.4
463.2
delay in µs
0
-8
magnitude in dB
magnitude in dB
Filter characteristic
0.25
465
Construction and pin connection
(All dimensions in mm)
7
SQ 3,81 +0,2/-0,1
5
456Q
● U49
1
3
1
2
3
4
5
6
7
8
Ground
Input RF Return
Input
Ground
Ground
Output RF Return
Output
Ground
Date code:
U
V
W
...
Year + week
2006
2007
2008
5
0,1
7
0,6
12
0%
%
d
3
1,78
2,54
1
1,2 Max.
Date code
1,78
50 Ohm Test circuit
L1
3
2
7
SAW
L2
6
C2
C1
1, 4, 5, 8
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456q.doc
Version 1.2
VI TELEFILTER
08.12.2006
Filter specification
TFS 456Q
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: three times max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
P1
Tape (all dimensions in mm)
W
: 12,00 ± 0,3
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,1
F
: 5,50 ± 0,05
G(min)
: 0,75
P2
: 2,00 ± 0,05
P1
: 8,00 ± 0,1
D1(min)
: 1,50
Ao
: 4,30 ± 0,1
Bo
: 4,30 ± 0,1
Ct
: 9,5 ± 0,1
t
PIN Marker
Po
P2
W
G
Ct
Bo
F
G
E
Do
Ko
Date Code
Typ
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 12,4 +2/-0
W2(max) : 18,4
N(min)
: 50
C
: 13,0 +0,5/-0,2
C
A
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456q.doc
Version 1.2
VI TELEFILTER
08.12.2006
Filter specification
TFS 456Q
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456q.doc
VI TELEFILTER
Version 1.2
Filter specification
08.12.2006
TFS 456Q
5/5
History
Version
Reason of Changes
Name
Date
1.0
- generation of filter specification
- added termination impedances
- added typical values
- added filter characteristic
- added test circuit
E. Chilla
15.12.2005
1.1
- changed typical values
- changed filter characteristic
- changed termination impedances
E. Chilla
03.04.2006
1.2
- add input power level
Strehl
08.12.2006
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.