www.osram.com/LED-Systems LINEARlight DRAGON Slim - LD06S Data Sheet Benefits Picture for Datasheet is missing !!! Slim powerfull LED lightsource Plug-and-play connection Robust metall-case and accessories allow for versatile use Applications Display case lighting Shelve / furniture lighting Small coves Technical Operating Data Product Color Number of LEDs Voltage [V DC]* Power [W]* Current [A]* Radiance Angle [°]* Wavelength [nm] Color Temp [K]* Lum. Flux [lm]* LD06S-W4F-840 LD06S-W4F-830 white white 6 6 24 24 6,8 6,8 0,29 0,29 120 120 4000 K 3000 K 240 240 *) All Data are related to the entire module Due to the special conditions of the manufacturing processes of LED the typical data of technical parameters can only reflect statistical figures and do not necessarily correspond to the actual parameters of each single product which could differ from the typical data. +) Preliminary Data **) Discontinued Technical Features 6 LED Golden Dragon per module A maximum of 5 modules can be installed consecutively with power feed from one end. Size of entire module: (L x W x H): 300 mm x 16 mm x 15 mm Easy and versatile mounting options with Operation only with OPTOTRONIC® power supplies: OT20, OT20S, OT75, OT75E Dimmable by pulse width modulation (PWM) standard accessories The metall housing grants sufficient cooling in with the electronic controller OT DIM Conformal coating protects against normal conditions. condensation water Plug-and-play connection Up to 50,000 h lifetime LD06S - 19.04.2011 Page 1 of 4 Minimum and Maximum Ratings Product Operating Temperature at Tc-Point [ °C ] * Storage Temperature [ °C ] * Voltage Range [ V dc ] * Reverse Voltage [ V dc ] * LD06S-W4F-840 -20 ... 85 -20 ... 85 23 ... 25 30 LD06S-W4F-830 -20 ... 85 -20 ... 85 23 ... 25 30 *) Exceeding maximum ratings for operating and storage temperature will reduce expected life time or destroy the LED Module. Exceeding maximum ratings for operating voltage will cause hazardous overload and will likely destroy the LED Module. The temperature of the LED module must be measured at the Tc-point according to EN60598-1 in a thermally constant status with a temperature sensor or a temperature sensitive label. For exact location of the Tc-point see drawing below. Drawings Drawing is missing !!! LD06S - 19.04.2011 Page 2 of 4 Safety Information The LED module itself and all its components must not be mechanically stressed. Assembly must not damage or destroy conducting paths on the circuit board. In order to drive OSRAM LED-Modules safely, it is absolutely necessary to operate them with an electronically stabilised power supply protecting against short circuits, overload and overheating. To also ease the luminaire/installation approval, electronic control gear for LED or LED modules should carry the CE mark and be ENEC certified. In Europe the declarations of conformity must include the following standards: CE: EC 61347-2-13, EN 55015, IEC 61547 and IEC 61000-3-2 - ENEC: 61347-2-13 and IEC/EN 62384. Also check for the mark of an independent authorized certification institute. Please see the relevant brochure for more detailed information (see "Related and Further Information") OSRAM OPTOTRONIC® electronic control gear complies to all relevant standards and guarantees safe operation. Installation of LED modules (with power supplies) needs to be made with regard to all applicable electrical and safety standards. Only qualified personnel should be allowed to perform installations. Observe correct polarity! Depending on the product incorrect polarity will lead to emission of red or no light. The module can be destroyed! Correct polarity immediatelly! (see "reverse voltage", page 2) Parallel connection is highly recommended as safe electrical operation mode. Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload and damage the LED module. The module is not divisible. Attachement of the module with the supplied plastic clipsis susceptible to vibration. Maximum 5 modules may be driven in a row / per power feed. We recommend the operation with the power supplies OSRAM OPTOTRONIC OT 8, OT 20 (S) or OT 75 (E). Dimming/ colorcontrolling is only possible with PWM. Please refer to the maximum current of controllgear when calculating the whole installation (OT DIM / OTi DALI DIM: 5A). Please read our OPTOTRONIC technical information guide for more detailed information about calculating and wiring diagrams. LD06S - 19.04.2011 Page 3 of 4 Assembly Information The housing provides sufficient in standard indoor air-conditions. For higher requirements we recommend an extensive contact with an e.g. metallic face without air gaps or sufficient airflow. Connection only with the included connectors. Make sure that the red cable is connected to the (+) pole and the black one to the (-) pole. A mechanical fixing is required when two modules are connected end to end with the module interconnector. The long hexagonal interconnecting bar should be put in the backside slot of modules and fixed with the enclosed screws. The enclosed plastic clip allows easy installation of longer module runs. In case of vibration additional fixings are required. The enclosed metal brackets enable adjustable tilting of the modules. Ordering Guide S-Unit * Productgroup Productname EAN * LINEARlight DRAGON Slim LD06S-W4F-840 4008321953322 6 LINEARlight DRAGON Slim LD06S-W4F-830 4008321953308 6 *) EAN: Ordering number per single module S-Unit: Modules per shipping unit Note: Typical performance data are subject to change without any further notice, particularly as LED technology evolves. Sales and Technical Support OSRAM GmbH Hellabrunner Strasse 1 D - 81536 München Germany www.osram.com +49 (0)89 6213-0 Sales and technical support is given by the local OSRAM subsidiaries. On our world wide homepage all OSRAM subsidiaries are listed with complete address and phone numbers. Related and Further Information OSRAM LED systems A new approach to light www.osram.com/led-systems 153 S006 GB www.osram.com/led-systems-downloads 130 T008 GB www.osram.com/ecg-downloads http://catalog.myosram.com www.osram.com/led-systems-downloads 130 W011 GB www.osram.com/ecg-download OPTOTRONIC® Technical Guide OPTOTRONIC® Data Sheets Eulumdat Files New standards for LED control gear LD06S - 19.04.2011 Page 4 of 4