POSEICO POSEICO SPA POwer SEmiconductors Italian COrporation RECTIFIER DIODES MODULE *Full ermetic packaging *Industrial compatible packaging *Insulation using Aln substrate *Contact screws avaliable on request POSEICO SPA Via N. Lorenzi 8, 16152 Genova - ITALY Tel. +39 010 6556234 - Fax +39 010 6557519 Sales Office: Tel. +39 010 6556775 - Fax +39 010 6442510 ADD500HVI Repetitive voltage up to Mean on-state current Surge current 3300 V 500 A 10.3 kA TARGET SPECIFICATION mag 03 - ISSUE : 1 Symbol Characteristic Tj [°C] Conditions Value Unit BLOCKING V RRM Repetitive peak reverse voltage 150 3300 V V RSM Non-repetitive peak reverse voltage 150 3400 V I RRM Repetitive peak reverse current 150 50 mA 500 A CONDUCTING I F (AV) Mean on-state current 180° sin, 50Hz, Tc=85°C I F (AV) Mean on-state current 180° sin. 50Hz, Tc=55°C I FSM Surge on-state current sine wave, 10 ms 650 A 150 10,3 kA 530 x1E3 A²s 150 1,97 I² t I² t without reverse voltage V F On-state voltage On-state current = V F(TO) Threshold voltage 150 0,89 V F On-state slope resistance 150 0,675 mohm r 1600 A V MOUNTING R th(j-c) Thermal impedance Junction to case, per element 70 °C/kW R th(c-h) Thermal impedance Case to heatsink, per element 20 °C/kW T j Operating junction temperature -30 / 150 °C V ins RMS insulation voltage 50Hz, circuit to base,all terminal shorted Mounting tourque Case to heatsink Busbars to terminals T Mass ORDERING INFORMATION : ADD500HVI S 33 standard specification VRRM/100 25 6000 V 4 to 6 12 to 18 1500 Nm Nm g ADD500HVI RECTIFIER DIODES MODULE TARGET SPECIFICATION POSEICO POSEICO SPA POwer SEmiconductors Italian COrporation mag 03 - ISSUE : 1 SURGE CHARACTERISTIC Tj = 150 °C ON-STATE CHARACTERISTIC Tj = 150 °C 12 1400 10 1000 8 800 ITSM [kA] On-state Current [A] 1200 600 6 4 400 2 200 0 0,75 1,25 1,75 0 2,25 1 On-state Voltage [V] 10 n° cycles TRANSIENT THERMAL IMPEDANCE 80,0 70,0 Zth j-c [°C/kW] 60,0 50,0 40,0 30,0 20,0 10,0 0,0 0,001 0,01 0,1 1 10 100 t[s] Distributed by All the characteristics given in this data sheet are guaranteed only with uniform clamping force, cleaned and lubricated heatsink, surfaces with flatness < .03 mm and roughness < 2 µm. In the interest of product improvement POSEICO SPA reserves the right to change any data given in this data sheet at any time without previous notice. If not stated otherwise the maximum value of ratings (simbols over shaded background) and characteristics is reported. 100