Download Data Sheet

DATASHEET
Rev. A
PSM360 SERIES
90~264VAC Input Voltage Range
360 Watts with 30CFM Forced Airflow
Active PFC, Single Output
Medical AC/DC Switching Power Supplies
Type U
Type E
Type F
FEATURES
● Active PFC
● Single Output
● Remote Inhibit Function
● 5V / 1A Standby Output
● 12V / 1A Output for Fan
● 90~264Vac Input Voltage Range
● 360W with 30CFM Forced Airflow
● Current Sharing Option (Single Wire)
● Short Circuit, Over Load, and Over Voltage Protection
● UL60601-1, CB IEC60601-1, TUV EN60601-1 Safety Approvals
● 3 Mechanical Options Available: U-Chassis, Enclosed with Rear Side Fan, Enclosed with Top Fan
DESCRIPTION
The PSM360 series of medical AC/DC switching power supplies offers 360 watts of output power with 30CFM forced
airflow. All models have a single output, 90~264VAC full range input, and active PFC. These supplies also have
UL60601-1, TUV EN60601-1, CB IEC60601-1, and CE safety approvals. All models are protected against short circuit,
over load, and over voltage conditions. Models are available in U-Chassis (Type U), enclosed with rear side built-in fan
(Type E), and enclosed with top built-in fan (Type F) designs. This series also has a current sharing option (suffix “D”).
04/27/2010
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
Page 1 of 7
Rev. A
PSM360 Series
Up to 360 Watts
Active PFC, Single Output
Medical AC/DC Switching Power Supply
SPECIFICATIONS: PSM360 Series
All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted.
We reserve the right to change specifications based on technological advances.
INPUT SPECIFICATIONS
Input Voltage Range
Input Frequency
Input Current
Inrush Current
Power Factor
OUTPUT SPECIFICATIONS
Output Current
Output Voltage
Output Regulation (See Note 3)
Output Power
Ripple & Noise (20MHz BW) (See Note 4)
Hold Up Time
Temperature coefficient
90 ~ 264Vac (Full Range)
47 ~ 63Hz
4.5A max. at 115Vac
< 30A peak at 115Vac cold start and 25°C
< 80A peak at 230Vac cold start and 25°C
> 0.9 at 115Vac/230Vac
See Table
See Table
5%
360W max. with 30CFM forced air cooling
±1%
20ms typical at 115Vac input
±0.04%/°C
PROTECTION
Short Circuit Protection
Over Voltage Protection
Over Load Protection
GENERAL SPECIFICATIONS
Auto-recovery
110% to 130% above nominal output. Latching type, AC recycle
110% to 150% maximum rating. Auto-recovery
Efficiency
83% typical at 115Vac and full load
86% typical at 230Vac and full load
Isolation Voltage
Input to Output: 5656Vdc
Input to Ground: 2121Vdc
Output to Ground: 707Vdc
Leakage Current
Current Share Option (See Note 1)
< 300µA at 264Vac
Single wire (add the suffix “D” to the part number)
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature
Humidity (non-condensing)
MTBF
PHYSICAL SPECIFICATIONS
0°C to +50°C ambient; each output derates at 2.5% per degree from +50°C to +70°C
5% to 95%
>100,000 hours at full load and 25°C ambient temperature
Dimensions (L x W x H)
U Type: 8.00 x 4.66 x 1.51 inches (203.2 x 118.5 x 38.5 mm)
E Type: 9.03 x 4.66 x 1.63 inches (229.4 x 118.5 x 41.5 mm)
F Type: 8.00 x 4.66 x 2.85 inches (203.2 x 118.5 x 72.5 mm)
Weight
U Type: 40oz (1134g)
E Type: 52.8oz (1497g)
F Type: 52.8oz (1497g)
SAFETY & EMI
Safety Standards
EMI Standards
04/27/2010
UL 60601-1, CSA-C22.2 NO.601.1-M90, TUV EN60601-1, CB IEC60601-1
EN60601-1-2, FCC Part 18 Class B, EN55011 Class B, CE
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
Page 2 of 7
PSM360 Series
Up to 360 Watts
Active PFC, Single Output
Medical AC/DC Switching Power Supply
Rev. A
MODEL SELECTION TABLE
Model (1)
Input Voltage
Output Voltage
Output Current
(30CFM forced air)
Maximum Output Power (2)
(30CFM forced air)
PSM360B-1Y12-X (D)
90 ~ 264 VAC
12 VDC
30A
360W
PSM360B-1Y24-X (D)
90 ~ 264 VAC
24 VDC
15A
360W
PSM360B-1Y30-X (D)
90 ~ 264 VAC
30 VDC
12A
360W
PSM360B-1Y36-X (D)
90 ~ 264 VAC
36 VDC
10A
360W
PSM360B-1Y48-X (D)
90 ~ 264 VAC
48 VDC
7.5A
360W
PSM360B-1Y54-X (D)
90 ~ 264 VAC
54 VDC
6.67A
360W
PSM360B-1Y57-X (D)
90 ~ 264 VAC
57 VDC
6.32A
360W
NOTES
1. Mechanical Options: The “x” in the part number can be “U” for U-chassis type, “E” for enclosed type with rear
side built-in fan, or “F” for enclosed type with top side built-in fan. The “D” is for current sharing option.
2. U Type: 360W max. with 30CFM forced air at +50°C ambient temperature.
E Type: 360W max. at +50°C ambient temperature.
F Type: 360W max. at +50°C ambient temperature.
3. At 25°C including initial tolerance, line voltage, load currents, and output voltages adjusted to factory settings.
4. Ripple & Noise is measured at 20MHz bandwidth with a tantalum 10µF in parallel with a 0.1µF ceramic
capacitor.
04/27/2010
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
Page 3 of 7
PSM360 Series
Up to 360 Watts
Active PFC, Single Output
Medical AC/DC Switching Power Supply
Rev. A
MECHANICAL DRAWINGS
Type “U” Models (U-Chassis Type): 8.00 x 4.66 x 1.51 inches
Unit: inches (mm)
0.35
(8.9)
0.35
(8.9)
0.50
(12.7)
0.50
(12.7)
7.30 (185.4)
2.35 (59.75)
0.32 (8.25)
3.66 (93.1)
CN4
1.05 (26.75)
0.32 (8.25)
CN1
0.50
(12.7)
0.50
(12.7)
4-M3P0.5
0.35
(8.9)
0.35
(8.9)
FAN FAULT
FAN
FULL SPEED
CN7 P2.54-2*3P
Molex P/N:90122-0123
or Equivalent
0.75 (19.0)
0.75 (19.0)
2-M3P0.5
7.30 (185.4)
0.35
(8.9)
POWER GOOD GND
GND
0.35
(8.9)
8.00 (203.2)
1.51 (38.35)
CN3
1
CN5
CN2
FAN1
FAN2
N.C.
Recommended direction
for forced airflow
REPLACE ONLY WITH
SAME TYPE AND RATING OF FUSE
+V
CN1
FG
IN
G
AC(L)
FG
04/27/2010
W
AR
0.47
(12.0)
N
AC(N)
AC(L)
RTN
RTN
CN4
0.75 (19.0)
AC(N)
+V
RTN
!!
8A/250V
+V
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
Page 4 of 7
PSM360 Series
Up to 360 Watts
Active PFC, Single Output
Medical AC/DC Switching Power Supply
Rev. A
Type “E” Models (Enclosed with Rear Side Built-in Fan Type): 9.03 x 4.66 x 1.63 inches
Unit: inches (mm)
7.30 (185.4)
0.35
(8.9)
0.5
(12.7)
2.35 (59.75)
0.32 (8.25)
CN4
3.66 (93.1)
1.05 (26.75)
0.32 (8.25)
CN1
4-M3P0.5
0.5
(12.7)
0.77 (19.5)
0.77 (19.5)
0.35
(8.9)
2-M3P0.5
0.35
(8.9)
7.30 (185.4)
FAN
FULL SPEED
CN7 P2.54-2*3P
Molex P/N:90122-0123
or Equivalent
POWER GOOD GND
0.35
(8.9)
GND
9.03 (229.4)
CN2
CN3
1
CN5
1
FAN1
4.66 (118.5)
N.C.
+V
+V
+V
CN1
RTN
8A/250V
FG
FG
RTN
RTN
CN4
0.47
(12.0)
L
AC(L)
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
1
0.75 (19.0)
N
AC(N)
RTN RTN RTN +V +V +V NC
1.63 (41.5)
04/27/2010
FAN FAULT
Page 5 of 7
PSM360 Series
Up to 360 Watts
Active PFC, Single Output
Medical AC/DC Switching Power Supply
Rev. A
Type “F” Models (Enclosed with Top Side Built-in Fan Type): 8.00 x 4.66 x 2.85 inches
Unit: inches (mm)
7.30 (185.4)
0.35
(8.9)
0.5
(12.7)
0.5
(12.7)
0.35
(8.9)
2.35 (59.75)
3.67 (93.1)
0.32 (8.25)
CN4
1.05 (26.75)
0.32 (8.25)
4-M3P0.5
CN1
0.5
(12.7)
0.5
(12.7)
0.35
(8.9)
0.35
(8.9)
7.30 (185.4)
0.35
(8.9)
0.35
(8.9)
FAN FAULT
FAN
FULL SPEED
0.75 (19.0)
0.75 (19.0)
2-M3P0.5
CN7 P2.54-2*3P
Molex P/N:90122-0123
or Equivalent
POWER GOOD GND
1.00 (25.5)
8.00 (203.2)
CN3
1
CN5
1
+V
+V
CN1
RTN
8A/250V
FG
FG
RTN
RTN
CN4
0.47
(12.0)
L
AC(L)
04/27/2010
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
0.75
(19.0)
N
AC(N)
+V
+V
+V
4.67 (118.5)
N.C.
NC
FAN1
+V
CN2
RTN RTN RTN
1.85 (47.0)
GND
Page 6 of 7
Rev. A
PSM360 Series
Up to 360 Watts
Active PFC, Single Output
Medical AC/DC Switching Power Supply
COMPANY INFORMATION
Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will
provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one
example of our commitment to producing a high quality, well-documented product for our customers.
Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its
customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for
your project above and beyond the design and production phases. Give us a call today to discuss your future projects.
Contact Wall Industries for further information:
Phone:
Toll Free:
Fax:
E-mail:
Web:
Address:
04/27/2010
(603)778-2300
(888)587-9255
(603)778-9797
[email protected]
www.wallindustries.com
5 Watson Brook Rd.
Exeter, NH 03833
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
Page 7 of 7