Filename: tfs 224a.doc Version 1.9 VI TELEFILTER 03.09.2004 Filter specification TFS 224A 1/5 Measurement condition : Ambient temperature TA: Input power level: Terminating impedances at fc * ) : 23 °C 0 dBm for input: for output:: 1200 1200 - 5,32 pF - 5,25 pF Characteristics Remark: The reference level for the relative attenuation arel of the TFS 224A is the minimum of the pass band attenuation. This value is defined as the insertion loss ae. The nominal frequency fN is fixed at 224,88 MHz without any tolerance. The values of relative attenuation arel are guaranteed for the whole operating temperature range. The frequency shift of the filter in the operating temperature range is included in the production tolerance scheme. Data typ. value Insertion loss (reference level) ae 6,5 Nominal frequency fN - Passband - Pass band ripple 0,5 Relative attenuation fN … fN ± 0,3 arel MHz tolerance / limit dB max. 9 224,88 fN dB ± 0,3 dB MHz MHz max. 1 dB - max. 1 dB fN ± 0,75 MHz … fN ± 2,4 MHz - min. 3 dB fN ± 2,4 MHz … fN ± 8 MHz 40 dB min. 33 dB fN ± 8 MHz … fN ± 15 MHz 47 dB min. 40 dB fN ± 15 MHz … fN ± 50 MHz 52 dB min. 45 dB 765 ns 765 50 ns Group delay mean value in PB Group delay ripple within PB ± 10 ns - Deviation from linear phase fN ± 0,675 MHz VSWR within PB Operating temperature range OTR Storage temperature range ° rms max. 3,5 ° rms 1,5 : 1 max. 2 : 1 - 30 °C ... + 80 °C - - 40 °C ... + 85 °C - Frequency inversion temperature Temperature coefficient of frequency 1,7 25 TCf ** -0,03 °C ppm/K 2 - *) The terminating impedances depend on parasites and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. f(Hz) = TCf(ppm/K²) x ( T)² x fTo(MHz) **) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 224a.doc B d ni e d ut i n g a m Version 1.9 03.09.2004 0 0 1.26 -10 -1 1.2 -20 -2 1.14 -30 -3 1.08 -4 B d ni e d ut i n g a m -40 -7 1.02 sµ 0.96ni y a 0.9 el d 0.84 -80 -8 0.78 -90 -9 0.72 -50 -60 -70 -100 205.9 209.7 213.5 217.3 221.1 224.9 228.7 232.5 236.3 240.1 243.9 frequency in MHz -5 -6 -10 0.66 224.15 224.3 224.45 224.6 224.75 224.9 225.05 225.2 225.35 225.5 225.65 frequency in MHz (All dimensions in mm) Date code 12 L1 1 2 3 4 5 6 7 8 9 10 11 12 Input RF Return Ground Ground Ground Ground Output Output RF Return Ground Ground Ground Ground Input Date code: S T U ... Year + week 2004 2005 2006 6 L2 C2 C1 7 1 2, 3, 4, 5, 8, 9, 10, 11 [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 224a.doc Version 1.9 VI TELEFILTER 03.09.2004 Filter specification TFS 224A 3/5 Stability characteristics : After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,50 ± 0,1 Bo : 7,50 ± 0,1 Ct : 13,5 ± 0,1 P1 t Do Ko Po PIN Marker Date Code Typ P2 D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 +2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. Air reflow temperature conditions Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 224a.doc Version 1.9 VI TELEFILTER 03.09.2004 Filter specification TFS 224A 4/5 1st and 2nd air reflow profile Name: Temperature: Time: pre-heating periods main-heating periods 150 °C - 170 °C over 200 °C 60 sec. - 90 sec. 20 sec. - 25 sec. peak temperature 255 °C ± 5 °C Chip-mount air reflow profile 260 240 220 200 temperature / °C 180 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 140 160 180 200 220 240 time / s ec. Table for temperature vs. time during the air reflow process Tolerance of temperatures: ± 5 °C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / °C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / °C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 224a.doc VI TELEFILTER Version 1.9 Filter specification 03.09.2004 TFS 224A 5/5 History Version Reason of changes Name Date 1.1...1.5 - generate filter specification of TFS 224A. Dunzow W. 11.02.2000. 1.6 - change limit values of group delay ( mean value in pass band ) from 763 ± 10 ns to 765 ± 10 ns according to customer requirement. Dunzow W. 12.09.2000. 1.7 - change marking. - correct termination impedance. Dunzow W. 29.10.2002. 1.8 - labelling changed - filter characteristic added - change remark - remove centre frequency Pfeiffer 16.08.2004 1.9 - labelling corrected Steiner 03.09.2004 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.