VECTRON TFS350C

Filename: tfs 350c.doc
Version 1.3
VI TELEFILTER
14.05.2004
Filter specification
TFS 350C
1/5
Measurement condition
Ambient Temperature:
23
Input Power Level:
0
Terminating Impedance at fc*:
C
dBm
input:
output:
70
58
// -11 pF
// -17 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of TFS 350C is the minimum of the pass band attenuation amin . This minimum is defined as the
insertion loss ae . The nominal frequency fN is fixed at 350 MHz without any tolerance. The given values for the relative attenuation arel and the group
delay ripple have to be reached at the frequencies given below, even if the centre frequency fc is shifted due to the temperature coefficient of frequency
TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. Value
Insertion Loss
(Reference Level)
ae = amin
18
Nominal Frequency
fN
-
Pass Band
Amplitude Ripple within PB
PB
-
dB
fN
max.
11,5 dB
Group Delay Variation within PB
80
arel
MHz
MHz
MHz
Storage Temperature Range
Turnover temperature To
Temperature Coefficient of frequency TCf**
ns
0,4 dB
45
dB
60
dB
Operating Temperature Range
max. 22
dB
350,0 MHz
Return loss
Relative Attenuation
fN
... fN ±
1,3
fN ±
5,0 MHz ... fN ±
30
fN ±
30
MHz ... fN ± 350
Limit
30
°C
- 0,036 ppm / K2
1,3 MHz
0,5 dB p-p
-
max. 100
max.
min.
min.
ns
0,7 dB
40
dB
50
dB
-40...
-55... +85
+85° C
°C
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions, do not hesitate to ask for an application note or contact our design team.
**) f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz)
generated:
checked / approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
[email protected]
Filename: tfs 350c.doc
Version 1.3
VI TELEFILTER
14.05.2004
Filter specification
TFS 350C
3/5
Stability Characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: twice max.;
for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
DIN IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer
3000
min 300 mm
min 500 mm
min 300 mm
EMBOSSED CARRIER
Tape (all dimensions in mm)
Do
W
Po
Do
E
F
G (min)
P2
P1
D1(min)
Ao
Bo
CT
:
:
:
:
:
:
:
:
:
:
:
:
24± 0,3
4
± 0,1
1,5
+ 0,1
1,75 ± 0,1
11,5 ± 0,1
0,6
2
± 0,1
8
± 0,1
1,5
5,5
± 0,1
11,9 ± 0,1
21,5 ± 0,1
Po
P
2
E
Ao
D
CT
F
1
W
Bo
G
P1
COVER
W 2
Reel (all dimensions in mm):
A
:
W1
:
W2 (max) :
330
24,4 +2
30,4
N (min)
:
60
C
:
13 +0,5/-0,2
A
C
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 350c.doc
Version 1.3
VI TELEFILTER
14.05.2004
Filter specification
TFS 350C
4/5
Air reflow temperature conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C – 170 °C
60 sec. – 90 sec.
main-heating periods
over 200 °C
20 sec. – 25 sec.
peak temperature
255 °C ± 5 °C
Chip-mount air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / s ec.
Table for temperature vs. Time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
Temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
Temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 350c.doc
VI TELEFILTER
Version 1.3
Filter specification
14.05.2004
TFS 350C
5/5
History
Version
Reason of Changes
Name
Date
1.0
generation of specification according to customer requirements
Pfeiffer
28.01.2002
1.1
typical value for return loss and extended storage temperature range added
Steiner
11.02.2002
1.2
typical values added
terminating impedance added
changed pinning ‘output rf return’
Pfeiffer
04.06.2002
1.3
package (pin 1 marker) modified
filter characteristic added
Pfeiffer
14.05.2004
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.