Filename: tfs 150c1.doc Version 1.4 VI TELEFILTER 30.07.2004 Filter specification TFS 150C1 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 3800 Ω || -0.7 pF 3800 Ω || -0.7 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS 150C1 is the minimum in the usable signal bandwidth. The maximum attenuation amax in the usable signal bandwidth is defined as the insertion loss ae. The reference frequency fc is the arithmetic mean value of the upper ( f6dB+ ) and lower (f6dB-) frequencies at the 6 dB filter attenuation level relative to the insertion loss ae . The nominal frequency fN is fixed at 150,4 MHz without tolerance. The usable singnal bandwidth has to be guaranteed also if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc Data typ. value Insertion loss (Reference level) ae 2,8 Nominal frequency fN - Centre frequency fC 150,41 MHz - 3 dB bandwidth BW 107 kHz - Usable signal band width Relative attenuation : dB tolerance / limit max. 5 dB 150,4 MHz - min. fN±10 kHz arel f6dB- - 75 f6dB+ + 50 kHz ... f6dB- - 50 kHz ... f6dB+ + 75 kHz kHz - min. min. 15 15 dB dB f6dB- - 125 f6dB+ + 75 kHz ... f6dB- - 75 kHz ... f6dB+ + 125 kHz kHz - min. min. 20 20 dB dB f6dB- - 250 f6dB+ + 125 kHz ... f6dB- - 125 kHz ... f6dB+ + 250 kHz kHz - min. min. 35 35 dB dB f6dB- - 500 f6dB+ + 250 f6dB+ + 330 f6dB+ + 397 kHz kHz kHz kHz kHz kHz kHz kHz - min. min. min. min. 50 50 40 50 dB dB dB dB f6dB- - 500 f6dB+ + 500 kHz ... f6dB- - 10 kHz ... f6dB+ + 10 MHz MHz - min. min. 55 55 dB dB - - 20 °C ... + 70 °C - - 30 °C ... + 85 °C ... ... ... ... f6dB- - 250 f6dB+ + 330 f6dB+ + 397 f6dB+ + 500 Operating temperature range Storage temperature range Temperature coefficient of frequency TCf Frequency inversion temperature T0 **) ca. – 0,036 ppm/K² 25 °C - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆f(Hz) = TCf(ppm/ K²) x (T-T0)² x fTo(MHz) Generated: Checked / approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 150c1.doc Version 1.4 VI TELEFILTER 30.07.2004 Filter specification TFS 150C1 2/5 Filter characteristic 0 -3 -10 -3.5 -20 -4 -30 -4.5 -5 -40 B d ni e d ut i n g a m B d ni e d ut i n g a m -50 -60 -5.5 -6 -70 -6.5 -80 -7 -90 -7.5 -100 149.9 150 150.1 150.2 150.3 150.4 frequency in MHz 150.5 150.6 150.7 150.8 -8 150.9 150.34 150.36 150.38 150.4 frequency in MHz 150.42 150.44 150.46 Construction and pin connection (All dimensions in mm) 8 6 TFS150C1 ● S31 2 1 50 Ω Test circuit 1 : 1 2 3 4 5 6 7 8 9 10 Input Input Ground Ground Ground Output Output Ground Ground Ground Date code: S T U ... Year + week 2004 2005 2006 50 Ω Test circuit 2: L4 L1 L2 50 Ω C2 C1 50 Ω C4 L3 C1 50 Ω 50 Ω C2 C1 C3 C2 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 150c1.doc Version 1.4 VI TELEFILTER 30.07.2004 Filter specification TFS 150C1 3/5 Stability characteristics After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,10 F : 7,50 ± 0,10 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 1,50 +0,1/-0 Ao : 7,60 ± 0,10 Bo : 9,60 ± 0,10 Ct : 13,5 t P1 Date Code Po P2 W G Ct Bo F G E Do Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 W2(max) : 22,4 N(min) : 50 C : 13,0 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 150c1.doc Version 1.4 VI TELEFILTER 30.07.2004 Filter specification TFS 150C1 4/5 Air reflow temperature conditions 1st and 2nd air reflow profile Name: Temperature: Time: pre-heating periods main-heating periods 150 °C - 170 °C over 200 °C 60 sec. - 90 sec. 20 sec. - 25 sec. peak temperature 255 °C ± 5 °C Chip-mount air reflow profile 260 240 220 200 temperature / °C 180 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 140 160 180 200 220 240 time / sec. Table for temperature vs. time during the air reflow process Tolerance of temperatures: ± 5 °C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / °C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / °C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 150c1.doc VI TELEFILTER Version 1.4 Filter specification 30.07.2004 TFS 150C1 5/5 History Version Reason of Changes Name Date 1.1 Generation of specification according to customer requirements. Dunzow W. 11.10.2001. 1.2 Change defenition of insertion loss. Change remark according to temperature dependence and production tolerance. Remove attenuation requirement at fN ± 910 kHz. Add selection at f6dB- -500 kHz. Define frequency range were ultimate rejection of 55 dB is measured. Dr. Wall 14.11.2001 1.3 Add formula for calculation of temperature dependence of frequency. Change frequency inversion temperature to 25 °C. Dr. Wall 24.04.2002 1.4 Correct termination impedances. Correct tape and reel. Add filter characteristic. Dr. Wall 27.07.2004 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.