Oscilent Corporation RF SAW Filter | 805-RF433.92M-B Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 805-RF433.92M-B 5.0 x 5.0 SMD Remote Control Jan. 01, 2007 . TYPE : Remote Control, RF SAW Filter PART NUMBER : 805-RF433.92M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Minimum Insertion Loss Passband Relative Relative Attenuation Condition Minimum Typical Maximum Units - - 433.92 - MHz 433.8 ~ 434.12MHz - 2.2 4.0 dB 434.76 ~ 434.08 MHz - - 2.0 433.74 ~ 434.10 MHz - - 3.0 433.68 ~434.16 MHz - - 6.0 10.0 ~ 414.0 MHz 45 48 - dB 414.0 ~ 428.0 MHz 40 43 - 428.0 ~ 432.92.0MHz 15 19 - 434.92 ~ 442.0 MHz 10 14 - 442.0 ~ 550.0 MHz 35 38 - 550.0 ~ 1000.0 MHz 45 50 - Turnover To - 25 - Relative Pass bandwidth (BW3) - 670 720 - KHz Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm Maximum DC Voltage - - - 0 V Maximum Input Power - - - 10 dBm Operating Temperature - -45 - +120 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground G Ground H Ground dB deg. C Oscilent Corporation RF SAW Filter | 805-RF433.92M-B Page 2 of 2 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF433.92M-B