EIC1415A-8 14.40-15.40GHz 8-Watt Internally-Matched Power FET ISSUED DATE: 09/06/2007 FEATURES • • • • • • • 14.40–15.40GHz Bandwidth Input/Output Impedance Matched to 50 Ohms +39.0 dBm Output Power at 1dB Compression 5.5 dB Power Gain at 1dB Compression 26% Power Added Efficiency -42 dBc IM3 at Po = 28.5 dBm SCL 100% Tested for DC, RF, and RTH Caution! ESD sensitive device. ELECTRICAL CHARACTERISTICS (Ta = 25°C) IDSS PARAMETERS/TEST CONDITIONS1 Output Power at 1dB Compression f =14.4-15.4GHz VDS = 10 V, IDSQ ≈ 2200mA Gain at 1dB Compression f =14.4-15.4GHz VDS = 10 V, IDSQ ≈ 2200mA Gain Flatness f =14.4-15.4GHz VDS = 10 V, IDSQ ≈ 2200mA Power Added Efficiency at 1dB Compression f =14.4-15.4GHz VDS = 10 V, IDSQ ≈ 2200mA Drain Current at 1dB Compression f =14.4-15.4GHz Output 3rd Order Intermodulation Distortion ∆f = 10 MHz 2-Tone Test; Pout = 28.5 dBm S.C.L2 VDS = 10 V, IDSQ ≈ 65% IDSS f = 15.4GHz Saturated Drain Current VDS = 3 V, VGS = 0 V VP Pinch-off Voltage SYMBOL P1dB G1dB ∆G PAE Id1dB IM3 TYP 38.0 39.0 dBm 4.5 5.5 dB MAX UNITS ±0.6 dB 26 2300 -38 VDS = 3 V, IDS = 40 mA Thermal Resistance RTH MIN 3 % 2600 mA -42 dBc 4000 5000 -2.5 -4.0 3.5 mA V o 4.0 C/W Note: 1. Tested with 100 Ohm gate resistor. 2. S.C.L. = Single Carrier Level. 3. Overall Rth depends on case mounting. ABSOLUTE MAXIMUM RATING FOR EFE SYMBOLS Vds Vgs Igf Igr Pin Tch Tstg Pt PARAMETERS Drain-Source Voltage Gate-Source Voltage Forward Gate Current Reverse Gate Current Input Power Channel Temperature Storage Temperature Total Power Dissipation ABSOLUTE1 CONTINUOUS2 15V 10V -5V -4V 86.4mA 28.8mA -14.4mA -4.8mA 38.5dBm @ 3dB Compression 175C 175C -65C to +175C -65C to +175C 38W 38W Note: 1. Exceeding any of the above ratings may result in permanent damage. 2. Exceeding any of the above ratings may reduce MTTF below design goals. Specifications are subject to change without notice. Excelics Semiconductor, Inc. 310 De Guigne Drive, Sunnyvale, CA 94085 Phone: 408-737-1711 Fax: 408-737-1868 Web: www.excelics.com page 1 of 2 Revised October 2007 EIC1415A-8 14.40-15.40GHz 8-Watt Internally-Matched Power FET ISSUED DATE: 09/06/2007 PACKAGES OUTLINE Dimensions in inches, Tolerance + .005 unless otherwise specified EIC1415A-8 (Hermetic) EIC1415A-8NH (Non-Hermetic) Excelics Excelics EIC1415A-8 EIC1415A-8NH YYWW YYWW SN SN ALL DIMENSIONS IN INCHES ALL DIMENSIONS IN INCHES Caution! ESD sensitive device. Caution! ESD sensitive device. ORDERING INFORMATION Part Number Packages Grade1 fTest (GHz) P1dB (min) IM3 (min)2 EIC1415A-8 Hermetic Industrial 14.40-15.40GHz 38.0 -38 EIC1415A-8NH Non-Hermetic Industrial 14.40-15.40GHz 38.0 -38 Notes: 1. Contact factory for military and hi-rel grades. 2. Exact test conditions are specified in “Electrical Characteristics” table. DISCLAIMER EXCELICS SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. EXCELICS DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN. LIFE SUPPORT POLICY EXCELICS SEMICONDUCTOR PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF EXCELICS SEMICONDUCTOR, INC. AS HERE IN: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, or (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in significant injury to the user. 2. A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness Specifications are subject to change without notice. Excelics Semiconductor, Inc. 310 De Guigne Drive, Sunnyvale, CA 94085 Phone: 408-737-1711 Fax: 408-737-1868 Web: www.excelics.com page 2 of 2 Revised October 2007