HH-1355-6.3 Series JMK Inc The HH-1355-6.3C filter has been designed to operate with the VICOR Harmonic Attenuator Module (HAM). This filter was specifically designed to allow the Vicor HAM and associated power converters to meet Mil-Std-461C or Mil-Std-461D & E. The enclosure mounting, and pin configuration are identical to the enclosure for the standard HAM filter. It will be necessary to add transient protection across the output of the filter to protect the HAM module. It is recommended that you use 5%, bipolar TVS diodes. 2 x 130V and 1 x 150V diodes connected in series. The HAM will meet Mil-Std-461C with the HH-1355-6.3 with voltage inputs of 125 or 250 Vac. It will also meet Mil-Std-461D,E, or F with a 125 volt input. Additional circuitry is required on the input in order to meet Mil-Std-461D, E, & F if 250 volts is the input voltage. The additional circuitry is shown on the schematic. 4-40 INSERT .25 DP (4 PL) .080 DIA PIN (6 PL) 4.60 0.25 0.94 2.50 LINE 2.40 2.00 0.20 USA LOAD 0.30 0.50 1.46 1.80 0.50 2.80 0.06 0.13 ±0.02 JMK Inc 15 Caldwell Dr. Amherst, NH 03031 Operating voltage________________85 to 250 V~ Operating current ________________6.3 Amp Operating frequency______________50/400 Hz Operating temperature, High________See temp.curve Operating temperature, Low ________-20º C, Std ________ -40º C, HT & BHT ________ _55º C, CHT Diel. withstanding (line - case)_______1500 Vac Diel. withstanding (line - line)________1500 Vdc Leakage current__________________2.5 ma @ 220 V, 60 Hz Max residual voltage after 1 sec__ 34 Volts The filter is available in both the standard model and three wider temperature range models. The temperature ranges at full load are listed below: HH-1355-6.3_______(-20—40º C) HH-1355-6.3HT_____(-40—55º C) HH-1355-6.3BHT___ (-40—70º C) HH-1355-6.3CHT___ (-55—70º C) PH: 603 886-4100 FX: 603 886-4115 email: [email protected]