FF-2063-7.5 The FF-2063-7.5 filter has been designed to operate with the VICOR PFC MICRO. This filter was specifically designed to allow the MIL COTS PFC MICRO to meet the conducted emission requirements of Mil-Std-461D, E or F. The standard filter has a chassis mount enclosure but the filter enclosure can be modified to add a connector input or other terminals to suit your requirements. The leads are Teflon but can be changed if the Teflon is an issue. The filter is lead free and RoHS. Ordering Information Standard Unit: FF-2063-7.5 Operating Voltage = ___________________85 to 250 V~ Operating Current = ______________________ 7.5 Amp Operating Frequency = __________________ 50/400 Hz Operating Temperature, High = ______ See Temp.Curve Operating Temperature, Low = ___________ -20º C, Std = ____________-40º C, HT Storage Temperature = ______________-40º C—100º C Diel. Withstanding (L - Case) = _____________1500 Vac Diel. Withstanding (L - L) = ________________1500 Vdc Leakage Current = ____________ 1.2 ma @ 220V, 60Hz Max. Residual Volt. after 1 sec = ____________ 34 Volts Weight = _________________________________ 0.8 lb Calculated MTBF= ________22,214,817 hrs. @ 30°C GB Failure Rate = __________________________ 0.045015 USA JMK Inc 15 Caldwell Dr. Amherst, NH 03031 EUR JMK Inc Glasgow, Scotland UK INSERTION LOSS vs. FREQUENCY PH: 603 886-4100 FX: 603 886-4115 email: [email protected] PH: 44 (0) 7785-310729 FX: 44 (0) 1415-891884