MPD MPM-03S-03

MPM-03 Series
Si l Output,
Single
O
3W
Ultra-Miniature DIP
AC/DC Power Supplies
Electrical Specifications
Key Features:
• 3W Output Power
• Universal 85-264 VAC Input
• -20ºC to +85ºC Operation
• Single Regulated Output
• >200 kHour MTBF
• Ultra-Miniature DIP Case
Specifications typical @ +25°C, 230 VAC input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min.
Input Voltage Range
Input Frequency
Input Current
Typ.
Max.
Units
85
264
VAC
120
370
VDC
47
63
Hz
See Model Selection Guide
Inrush Current
EMI
115 VAC
7.0
230 VAC
14.0
A Pk
Meets EN55022
Safety Ground Leakage Current
115 VAC
0.1
230 VAC
0.3
mA
Output
Parameter
Conditions
Min.
Typ.
Output Voltage
See Model Selection Guide
Output Current
See Model Selection Guide
Output Voltage Accuracy
±1.0
Line Regulation
RoHS Compliant
Load Regulation
Max.
Units
±1.0
%
±0.2
See Model Selection Guide
Ripple & Noise (20 MHz)
50
Hold-Up Time
115 VAC
20
230 VAC
80
Starting Delay
mV Pk - Pk
mSec
<1
Temperature Coefficient
S
±0.02
Short Circuit Protection
Continuous (Autorecovery)
Overload Protection
Typ. 110% of Output Power
%/°C
General
Parameter
Isolation Voltage
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Conditions
2,500
Input to Ground
2,000
Output to Ground
Switching Frequency
Typ.
Max.
Units
VAC
500
40
130
kHz
Environmental
Parameter
Conditions
Operating Temperature Range
T: (781) 344-8226
F: (781) 344-8481
E: [email protected]
W: www.micropowerdirect.com
Min.
Input to Output
Ambient
Storage Temperature Range
Min.
Typ.
Max.
Units
-20
+25
+85
°C
+105
°C
-25
Cooling
Free Air Convection (See Derating Curve)
Humidity
RH, Non-condensing
85
%
Physical
Case Size
1.46 x 0.90 x 0.59 Inches (37.0 x 23.0 x 15.0 mm)
Case Material
Non-Conductive Black Plastic (UL94-V0)
Weight
3.77 Oz (107g)
Reliability Specifications
Parameter
MTBF
Conditions
Min.
MIL HDBK 217F, 25°C, Gnd Benign
200
Typ.
Max.
Units
kHours
Model Selection Guide
Input
Model
Number
MPM-03S-03
MPM-03S-05
MPM-03S-09
MPM-03S-12
MPM-03S-15
MPM-03S-24
Output
Current (A)
115 VAC
230 VAC
0.08
0.08
0.08
0.08
0.08
0.08
0.05
0.05
0.05
0.05
0.05
0.05
Voltage
(VDC)
3.3
5.0
9.0
12.0
15.0
24.0
Ripple &
Noise
Current (mA)
Load
Typ.
Reg.
700
±1.0%
500
±1.0%
300
±1.0%
250
±1.0%
200
±1.0%
120
±1.0%
(mV)
<150
<100
<100
<100
<100
<100
Efficiency
(%, Typ)
65
70
71
72
72
70
Notes:
1. Load regulation is measured for an output change of 10%
to 90% at nominal input line. For multiple output models,
the loads are balanced.
2. It is recommended that a fuse be used on the input of
a power supply for protection. For the MPM-05 series, a
1A/250 VAC slow blow should be used.
Typical Connection
The diagram above illustrates a typical application connection of
the MPM-03 series. Notes on this circuit (starting with the input
circuit) are:
Mechanical Dimensions
1. To maintain clearance and creepage distances (for Class I & Class II
devices) the board layout should guarentee the following spacing
between the L and N inputs (before the fuse):
Clearance - 2 mm
Creepage - 2.5 mm
2. The recommended fuse is a 1A/250V slow blow. A 10Ω/2W wire
wound resistor may also be used.
3. For EMI sensitive applications, the input filtering circuit (inside the
dotted boxes) may be added. The filter consists of:
Cx: Capacitors C1, C2 and C3 are 0.01 µF/275V
CY: 102 kµF/400V
T1: Common mode choke, UU9.8 or ring core. Inductance is
about 10 mH & wire diameter of 0.22 mm.
4. The MOV is added for protection. Recommended is a 471KD07.
5. The input filtering capacitor (C4) is an electrolytic 4.7 µF/400V. This
capacitor can be removed if the application input is between 160
to 264 VAC.
6. The output filtering capacitor (C5) is a high frequency, low resistance electrolytic capacitor.
7. The TVS is recommended to protect application circuitry in the
event of a fault.
Derating Curve
Notes:
• All dimensions are typical in inches (mm)
• Tolerance x.xx = ±0.01 (±0.25)
Pin Connections
MicroPower Direct
Pin
Function
1
3
13
14
16
22
26
AC-Line
AC-Neutral
NC
-Vout
+Vout
+Vin (DC)
-Vin (DC)
www.micropowerdirect.com
292 Page Street Ste D Stoughton, MA 02072
•
TEL: (781) 344-8226
•
FAX: (781) 344-8481
•
E-Mail: [email protected]