RF SAW Filter Part Number Package Application Last Modified 803-RF430.0M-A 3.8 x 3.8 SMD Wireless Mar. 2 2007 . TYPE : Wireless RF SAW Filter PART NUMBER : 803-RF430.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Condition Minimum Typical Maximum Units - - 430.0 - MHz 428.0 ~ 432.0 MHz - 3.7 4.5 dB Fo-100 ~ Fo-40.8 MHz 50 62 - Fo+40.8 ~ Fo+100 MHz 50 61 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm Attenuation: dB 428.0 ~ 432.0 MHz - 1.5 2.0 dBp-p Maximum Input Power - - - 0 dBm Maximum DC Voltage - - - 10 V Operating Temperature - -10 - +65 ºC Amplitude Ripple * No Matching Network (Ref. Testing Environment Circuit as shown) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF430.0M-A