RF SAW Filter Part Number Package Application Last Modified 802-RF858.5M-A 3.0 x 3.0 SMD Wireless Mar. 10, 2007 . TYPE : Low Loss RF SAW Filter for Wireless Communication PART NUMBER : 802-RF858.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Source Impedence (single ended)* Condition Minimum Typical Maximum Units - - 858.5 - MHz 851.0~ 866.0 MHz - 2.2 3.5 dB DC~ 806.0 MHz 45 55 - 806.0~ 821.0 MHz 40 50 - 896.0~ 902.0MHz 28 34 - 905.825~ 924.825 MHz 27 39 - dB 960.0~ 979.0 MHz 37 53 - 1070.0~ 1089.0 MHz 47 51 - 1089.0~ 3000.0 MHz 27 32 - - - 50 - ohm ohm - - 50 - VSWR 851.0~ 866.0 MHz - 1.6 2.0 - Amplitude Ripple 851.0~ 866.0 MHz - 0.6 1.5 dBp-p - - - 5 V Load Impendance (single ended)* Maximum DC Voltage 851.0~ 866.0 MHz - 15 40 nsp-p Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +70 ºC Group Delay Ripple * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF858.5M-A