Version 3.2 File name: Tfs150N.doc VI TELEFILTER Filter specification 13.01.2003 TFS 150N 1/5 1. Measurement condition Ambient temperature T A: Input power level: Terminating impedances at fc * ) : 23 °C 0 dBm. for input: 280 - 22,7 pF. for output: 210 - 27,0 pF. 2. Characteristics Remark: Reference level for the relative attenuation arel of the TFS 150N is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The reference frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae . The temperature coefficient of frequency Tcf is valid both for the reference frequency f c and the frequency response of the filter in the operating temperature range. The frequency shift of the filter in the operating temperature range is not included in the production tolerance scheme. Data typ. value tolerance / limit 24,7 dB max. 150,01 MHz 150,0 ± 0,1 4,50 MHz fC ... fC ± 2,05 MHz 0,5 dB max. 1 dB 1 dB 3 dB 4,62 4,77 MHz MHz min. min. 4,1 4,6 MHz MHz 25 dB 40 dB 45 dB 5,22 5,33 5,36 MHz MHz MHz max. max. max. 5,3 6,0 6,4 MHz MHz MHz max. max. 1 3 dB dB dB dB min. min. min. 25 40 45 dB dB dB µs ns degree max. 4,5 max. 120 - Insertion loss (reference level) ae = amin Centre frequency at ambient temperature TA fc Pass band PB Pass band ripple ( pāp ) : 25 dB MHz Bandwidth at ambient temperature TA Relative attenuation arel fC ... fC ± fC ± 2,05 MHz ... fC ± 2,05 MHz 2,30 MHz - fC ± 2,65 MHz ... fC ± fC ± 3,0 MHz ... fC ± fC ± 3,2 MHz ... fC ± 3,0 MHz 3,2 MHz 100 MHz 46 50...70 Group delay ( mean value in PB ) Group delay ripple in PB: Deviation from linear phase in PB (p-p): 3,92 100 2,7 Input VSWR (S11) in PB : Output VSWR (S22) in PB : Triple transit attenuation compared to main signal Crosstalk 15 15 50 60...70 Input power level dB dB dB dB max. Frequency inversion temperature ( To ) Temperature coefficient of frequency ( Tc f ) Frequency deviation of fc over temperature: ** ) Operating temperature range ( OTR ) Storage temperature range 20 °C - 0,036 ppm/K² fc(Hz) = Tcf(ppm/K) x (T - To)² x fO (MHz) - µs ns 20 dBm - - 33 °C ... + 85 °C - 40 °C ... + 85 °C *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) fO = fTo is reference frequency fc at frequency inversion temperature (To ) generated: W. Dunzow checked / approved: Dr. Bert Wall VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Version 3.2 File name: Tfs150N.doc VI TELEFILTER Filter specification 3 Construction and pin connection : 13.01.2003 2/5 (All dimensions in mm) 35 Max. TFS TFS 150N 150 N R22 Date code ø 0,45 ø 1 Date code: N P R .... Year + week 2001 2002 2003 .... Pin 2 Input. Pin 3 Input RF return. Pin 14 Output. Pin 15 Output RF return. Pin 1, 4, 9, 12, 13, 16, 21, 24 ā - Package ground. Pin 10, 11, 22, 23 not connected. 2,54 11 X 2,54 = 27,94 4. 50 matching network ( for details refer to application note ) : L1 50 L2 L3 50 Scheme 1 L4 L1 50 C1 L2 50 Scheme 2 C2 For final test we use scheme 1. VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Version 3.2 File name: Tfs150N.doc VI TELEFILTER Filter specification TFS 150N 13.01.2003 3/5 5. Stability characteristics : After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 ā 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Version 3.2 File name: Tfs150N.doc VI TELEFILTER Filter specification 13.01.2003 TFS 150N 4/5 6. Air reflow temperature conditions : 1st and 2nd air reflow profile Name: Temperature: Time: pre-heating periods 150 °C - 170 °C 60 sec. - 90 sec. main-heating periods over 200 °C 20 sec. - 25 sec. peak temperature 255 °C ± 5 °C Air reflow profile 260 240 220 200 temperature / °C 180 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 140 160 180 200 220 240 time / sec. Table for temperature vs. time during the air reflow process Tolerance of temperatures: ± 5 °C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / °C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / °C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Version 3.2 File name: Tfs150N.doc VI TELEFILTER Filter specification 13.01.2003 TFS 150N 5/5 7. History : Version Reason of changes Name Date 1.0 - generate development specification according to customer requirements Pfeiffer W. 02.08.2002 2.0 - incorporate 25dB bandwidth spec. - change to 35 * 13 metal package. M. Senior 14.10.2002 2.1 - change pin connection. W. Dunzow 29.11.2002 3.1 - generate preliminary specification ; st - add typical values of filter after 1 iteration . W. Dunzow 07.01.2003 3.2 - generate filter specification ; - change insertion loss : from max. 24 dB to max. 25 dB. - add input power level : max. 20 dBm. W. Dunzow 13.01.2003 VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.