BNC Twinax Jack Connector Clamp/Solder Attachment For RG108, 78 Ohm Twinax TECHNICAL DATA SHEET PE4237 BNC Twinax Jack Connector Clamp/Solder Attachment For RG108, 78 Ohm Twinax Configuration Connector Connector Specification Connector Interface Type Cable Attachment Method (Shield/Contact) Body Style BNC Twinax Jack MIL-C-39012 RG108,78 Ohm Twinax Clamp/Solder Straight Electrical Specifications Impedance, Ohms 78 Mechanical Specifications Temperature Operating Range, deg C -65 to +165 Size Length, in [mm] Width/Dia., in [mm] 1.17 [29.72] 0.57 [14.48] Weight, lbs [g] 0.041 [18.6] Connector Type Contact Material and Plating Contact Plating Specification Body Material and Plating Dielectric Type BNC Twinax Jack Silver QQ-S-365 Brass, Nickel Teflon . Compliance Certifications (visit www.Pasternack.com for current document) RoHS Compliant Yes Plotted and Other Data Notes: Values at 25 °C, sea level BNC Twinax Jack Connector Clamp/Solder Attachment For RG108, 78 Ohm Twinax from Pasternack Enterprises has same day shipment for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of the broadest selection in the industry. Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: BNC Twinax Jack Connector Clamp/Solder Attachment For RG108, 78 Ohm Twinax PE4237 URL: http://www.pasternack.com/bnc-twinax-jack-standard-rg108-78-ohm-twinax-connector-pe4237-p.aspx PE4237 REV 1 © 2013 Pasternack Enterprises All Rights Reserved PE4237 REV REV. - CAD FILE 042309 SCALE N/A SIZE A 147 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES [mm]. 4. FITS MIL-C-17 AND EQUIVALENT CABLES. FSCM NO. 53919 PE4237 DWG TITLE * WHEN SOLDERING CONTACTS MAKE SURE SAME SEX IS ON BOTH ENDS OF WIRE IDENTIFIED BY THE BARE COPPER WIRE. 2. STRIP CABLE TO DIMENSION SHOWN. SLIDE SMALL WASHER (5) & REAR INSULATOR (6) OVER DIELECTRICS. SOLDER CONTACTS (7) TO CENTER CONDUCTOR THROUGH HOLE IN CONTACT. CLEAN EXCESS SOLDER. SLIDE FRONT INSULATOR (8) OVER CONTACTS. SLIDE ASSEMBLY FORWARD INTO BODY & TIGHTEN. 1. SLIDE CLAMP NUT (1), WASHER (2) & GASKET (3) OVER CABLE. STRIP CABLE TO DIMENSION SHOWN. DO NOT NICK BRAID & DIELECTRIC. COMB OUT BRAID. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CLAMP (4) . SLIDE BRAID CLAMP (4) OVER BRAID & BUTT AGAINST JACKET. FORM BRAID OVER CLAMP NUT (4). TRIM BRAID FLUSH WITH SHOULDER OF BRAID CLAMP (4). ASSEMBLY PROCEDURES BNC Twinax Jack Connector Clamp/Solder Attachment For RG108, 78 Ohm Twinax PE4237 CAD Drawing 2