L P V- 2 0 20W Single Output Switching Power Supply series Features : Constant voltage design Universal AC input / Full range Withstand 300VAC surge input for 5 seconds Protections: Short circuit / Over current / Over voltage Cooling by free air convection Small and compact size Fully encapsulated with IP67 level (Note.7) Fully isolated plastic case Class power unit, no FG Pass LPS Suitable for LED lighting and moving sign applications 100% full load burn-in test Low cost, high reliability 2 years warranty LPS IP67 SPECIFICATION MODEL OUTPUT LPV-20-5 LPV-20-12 DC VOLTAGE 5V 12V 15V 24V RATED CURRENT 3A 1.67A 1.33A 0.84A CURRENT RANGE 0 ~ 3A 0 ~ 1.67A 0 ~ 1.33A 0 ~ 0.84A RATED POWER 15W 20W 20W 20.2W 120mVp-p 120mVp-p 150mVp-p 83% 83% RIPPLE & NOISE (max.) Note.2 80mVp-p VOLTAGE TOLERANCE Note.3 5.0% LINE REGULATION 1.0% Note.6 500ms, 20ms / 230VAC 50ms/230VAC HOLD UP TIME (Typ.) VOLTAGE RANGE INPUT Note.4 90 ~ 264VAC EFFICIENCY (Typ.) 77% AC CURRENT (Typ.) INRUSH CURRENT(max.) 0.55A/115VAC 0.35A/230VAC COLD START 35A/115VAC 70A/230VAC PROTECTION OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT 0.25mA / 240VAC 110 ~ 150% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16V 17.5 ~ 21V 28 ~ 32V Protection type : Shut off o/p voltage, clamping by zener diode -30 ~ +70 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing -40 ~ +80 , 10 ~ 95% RH VIBRATION SAFETY STANDARDS UL879, UL1310 Class 2, CAN/CSA C22.2 No. 223-M91, IP67 approved ; design refer to TUV EN60950-1, EN61347-2-13 WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3 ISOLATION RESISTANCE EMC EMISSION EMC IMMUNITY DIMENSION PACKING NOTE 81% 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes MTBF OTHERS 127 ~ 370VDC 47 ~ 63Hz OVER CURRENT EMC 500ms, 20ms / 115VAC at full load 16ms/115VAC at full load FREQUENCY RANGE LEAKAGE CURRENT SAFETY & LPV-20-24 2.0% LOAD REGULATION SETUP, RISE TIME LPV-20-15 Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 786.5Khrs min. MIL-HDBK-217F (25 ) 118*35*26mm (L*W*H) 0.22Kg; 60pcs/14.2Kg/0.62CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute. File Name:LPV-20-SPEC 2011-06-24 L P V- 2 0 20W Single Output Switching Power Supply Mechanical Specification Case No. 972A 600 30 118 series Unit:mm 600 30 UL1015 18AWG 17 UL1015 18AWG +V(Red) -V(Black) 28 2- 3.6 35 T case 3.5 AC/N(Blue) AC/L(Brown) 3.5 3.5 3.5 26 T case: Max. Case Temperature. Recommend Mounting Direction Block Diagram fosc : 65KHz EMI FILTER & RECTIFIERS I/P RECTIFIERS & FILTER POWER SWITCHING O.L.P. +V -V DETECTION CIRCUIT PWM CONTROL O.V.P. Derating Curve Static Characteristics 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -30 -15 0 15 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 90 100 125 135 145 155 165 175 180 200 230 264 INPUT VOLTAGE (V) 60Hz File Name:LPV-20-SPEC 2011-06-24