Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide Two-stage General Purpose RFI Power Line Filter R Series VR7/7M UL Recognized CSA Certified VDE Approved 1 VR3/ER3 RFI Power Line Filters 10VR6 VR1/ER1 R Series Specifications • Dual T section RFI filter provides premium performance • Well suited for low impedance loads where noisy RFI environments are present Maximum leakage current each Line to Ground: VR Models ER Models @120 VAC 60 Hz: .4 mA .21 mA @250 VAC 50 Hz: .7 mA .36 mA • Controls pulsed, continuous and/or intermittent interference Hipot rating (one minute): Line to Ground: Line to Line: • ER models offer low leakage current without deterioration of insertion loss Rated Voltage (max): 250 VAC Operating Frequency: 50/60 Hz 2250 VDC 1450 VDC Rated Current: Ordering Information 10E R 7 M Suffix M – Metric inserts (style 8 only) Omit for standard or none C – Ground choke (select models) Input / Output Style 1 – .250 [6.3] spade terminals 3 – Wire leads 6 – Threaded bolt 7 – IEC inlet* (line side) .250 [6.3] spade terminals (load side) R Series Leakage current designation E – Low leakage (<0.5 mA) V – Standard Current Rating 1, 2, 3, 5, 10 or 20A *IEC 60320-1 C14 inlet mates with C13 connector 1 to 20A Operating Ambient Temperature Range (at rated current Ir): -10°C to +40°C In an ambient temperature (Ta) higher than +40°C the maximum operating current (Io) is calculated as follows: Io = Ir (85-Ta)/45 Available Part Numbers 1VR1 1VR3 2VR1 2VR3 3VR1 3VR3 3VR7 3VR7M 5VR1 5VR3 5VR7 5VR7M 10VR1 10VR3 10VR6 10VR7 10VR7M 20VR1 20VR6 1ER1 1ER3 2ER1 2ER3 3ER1 3ER3 3ER7 3ER7M 5ER1 5ER3 5ER7 5ER7M 10ER1 10ER3 10ER7 10ER7M 20ER1 61 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide Two-stage General Purpose RFI Power Line Filter (continued) R Series Electrical Schematic Case Styles (continued) R3 LINE LOAD Blue Blue B Brown Brown A D E Green/ Yellow C Case Styles R1 (1, 2, 3, 5, 10A) 10VR6 B B D E A D E A C R1 (20A) E C 20VR6 D B E D B 2.00 2.00 50.8 50.8 A C A C 62 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide Two-stage General Purpose RFI Power Line Filter (continued) R Series Case Styles (continued) R7 & R7M Case Dimensions Part No. Tapped insert D B E C Recommended Panel Cutout .235 R 5.96 .157 Dia. (2) 3.98 .910 23.11 1.295 32.89 1.575 40.01 B C 1VR1, 1ER1, 2VR1, 2ER1 1VR3, 1ER1, 2VR3, 2ER3 3VR1, 3ER1, 5VR1, 5ER1 3VR3, 3ER3, 5VR3, 5ER3 3VR7/7M, 3ER7/7M 5VR7/7M, 5ER7/7M 10VR1, 10ER1 10VR3, 10ER3 10VR6 10VR7/7M, 10ER7/7M 20VR1, 20ER1 20VR6 D E 1 RFI Power Line Filters A A Accessories GA400: NEMA 5-15P to IEC 60320-1 C-13 line cord 63 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide Two-stage General Purpose RFI Power Line Filter (continued) R Series Performance Data Typical Insertion Loss Measured in closed 50 Ohm system 1ER 3ER 5ER 2ER, 10ER & 20ER db 100 db 100 db 100 db 100 90 90 90 90 80 80 80 80 70 70 70 70 60 60 60 60 50 50 50 50 40 40 40 40 30 30 30 30 20 20 20 20 10 10 10 0 0.1 1 0 10 30 Frequency in MHz 0.1 1 10 30 Frequency in MHz 0 10 0.1 1 0 10 30 Frequency in MHz 0.1 1VR 2VR 3VR 5VR db 100 db 100 db 100 db 100 90 90 90 90 80 80 80 80 70 70 70 70 60 60 60 60 50 50 50 50 40 40 40 40 30 30 30 30 20 20 20 20 10 10 10 0 0.1 1 0 10 30 Frequency in MHz 0.1 1 10VR 20VR db 100 db 100 90 90 80 80 70 70 60 60 50 50 40 40 30 30 20 20 10 0 10 30 Frequency in MHz 0 1 10 30 Frequency in MHz 1 10 30 Frequency in MHz 10 0.1 1 0 10 30 Frequency in MHz 0.1 Common Mode / Asymmetrical (L-G) Differential Mode / Symmetrical (L-L) 10 0.1 1 0 10 30 Frequency in MHz 0.1 1 10 30 Frequency in MHz Minimum Insertion Loss Measured in closed 50 Ohm system Common Mode / Asymmetrical (Line to Ground) Differential Mode / Symmetrical (Line to Line) 64 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com