SPECIFICATION CONTROL DRAWING MATERIALS 1. INSULATION SLEEVE: Heat shrinkable, transparent blue, radiation cross-linked polyvinylidene fluoride. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Sn63 per ANSI J-STD-006. FLUX: TYPE ROL1 per ANSI J-STD-004. APPLICATION 1. This part is designed to attach a tin or silver plated wire to terminals with 2.54 (0.100) or greater center spacing. Wire Accommodation: Jacket O.D.: 0.76 to 2.03 (0.030 to 0.080) Gauge: AWG 26 to 20 Connector Terminal: Max. Diagonal: 0.76 (0.030) Height: 5.08 to 7.62 (0.200 to 0.300) 2. Sleeve will recover to 0.76 (0.030) max. I.D. 3. This drawing forms part of Raychem Specification control Drawing: D-711-04, 2.54 (0.100) centers D-711-07, 3.18 (0.125) centers D-711-08, 3.96 (0.156) centers Tyco Electronics Corporation 300 Constitutional Drive Menlo Park, CA 94025 USA UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS. INCHES DIMENSIONS ARE BETWEEN BRACKETS. TOLERANCES: 0.00 N/A 0.0 N/A 0 N/A DRAWN BY: Tyco reserves the right to amend this drawing at any time. Users should evaluate the suitability of the product for their ROUGHNESS IN application. MICRON CAGE CODE: REPLACES: DCR NUMBER: TITLE: SOLDERSLEEVE WIRE TERMINATOR DOCUMENT NO.: D-141-31 ANGLES: N/A M. FORONDA 06090 N/A D000398 If this document is printed it becomes uncontrolled. Check for the latest revision. DATE: DOC ISSUE: 17-July-00 1 PROD. REV.: E SCALE: None SIZE: SHEET: A 1 of 1