SFT85707GW Solid State Devices, Inc. 14701 Firestone Blvd * La Mirada, CA 90638 Phone:(562) 404-4474 * Fax: (562) 404-1773 [email protected] * www.ssdi-power.com DESIGNER’S DATA SHEET Part Number / Ordering Information Dual Microminiature Package NPN & PNP Pair Small Signal / RF Transistor 1/ SFT85707 __ __ __ __ │ │ │ │ │ │ │ └ Screening 2/ __ = Not Screened TX = TX Level TXV = TXV Level S = S Level └ Package 3/ GW = GULLWING Features: High Speed, Saturated Switching, and Driver Applications Low Power IF and RF Amplifier Applications in the UHF Range TX, TXV, S-Level Screening Available 2/ Symbol 2N2857 NPN 2N2907 PNP Units Collector – Emitter Voltage VCEO 15 60 Volts Collector – Base Voltage VCBO 30 60 Volts Emitter – Base Voltage VEBO 3.0 5.0 Volts IC 40 600 mA PD 5/ 200 500 mW Maximum Ratings Collector Current TA = 25ºC Power Dissipation Per Device PD 5/ TA = 25ºC Total Power Dissipation (Junction to Ambient) Maximum Thermal Resistance Operating & Storage Temperature 660 mW RθJA 5/ 880 350 ºC/W TJ & TSTG -65 to +200 -65 to +200 ºC PACKAGE OUTLINE: GULLWING (GW) 2x .050 (=.100) .015 3x .015 .015±.010 PIN 6 PIN 4 PIN 4 6x .010 PIN 6 6x .030 SSDI .125 .193 .350 ±.010 .025 PIN 3 PIN 3 PIN 1 .034 5x R.018 PIN 1 .107 .040 ±.010 .107 .130 NOTE: All specifications are subject to change without notification. SCD's for these devices should be reviewed by SSDI prior to release. .010 6x R.010 .033 .035 DATA SHEET #: TR0079D DOC SFT85707GW Solid State Devices, Inc. 14701 Firestone Blvd * La Mirada, CA 90638 Phone:(562) 404-4474 * Fax: (562) 404-1773 [email protected] * www.ssdi-power.com Electrical Characteristics 4/ Symbol NPN Bias Limit PNP Bias Limit BVCEO IC=3 mA 15 V min IC = 10 mA -60 V min Collector – Base Leakage Current ICBO1 VCB = 30 V 1 uA max VCB = 60 V -10 uA max Emitter – Base Leakage Current IEBO VBE = 3 V 10 uA max VBE = 5 V VBE = 4 V -10 uA max -50 nA max ICBO2 VCB = 15 V VCB = 15 V, TA = 150ºC 10 nA max 1 μA max VCB = -50 V, TA = 25ºC VCB = -50 V, TA = 150ºC -10 nA max -10 μA max Emitter Cutoff Current ICES VCE = 16 V, VBE = 0 V 100 nA VCE = -50 V, VBE = 0 V 50 nA DC Current Forward Transfer Ratio * hFE IC = 3 mA, VCE = 1 V 30 - 150 –– –– hFE –– –– –– –– –– –– –– –– –– –– IC = 100 μA, VCE = 10 V IC = 1 mA, VCE = 10 V IC = 10 mA, VCE = 10 V IC = 150 mA, VCE = 10 V IC = 500 mA, VCE = 10 V 75 min 100 - 450 100 min 100 - 300 50 min hfe IC = 2 mA, VCE = 6 V 20 - 220 IC = 1 mA, VCE = 10 V 100 min 0.4 V max IC = 150 mA, IB = 15 mA IC = 500 mA, IB = 50 mA -0.4 V max -1.6 V max 1.0 V max IC = 150 mA, IB = 15 mA IC = 500 mA, IB = 50 mA -1.3 V max -2.6 V max Collector – Emitter Blocking Voltage * Collector Cutoff Current DC Current Forward Transfer Ratio * Small Signal Current Gain * (f = 1 kHz) Collector-Emitter Saturation Voltage * Base-Emitter Saturation Voltage * IC = 10 mA, IB = 1 mA VCE (SAT) VBE (SAT) IC = 10 mA, IB = 1 mA Small-Signal Power Gain Gpe IC = 1.5 mA, VCE = 6 V, f = 450 MHz 6/ 12.5 – 21 dB –– –– Noise Figure NF IC = 1.5 mA, VCE = 6 V, f = 450 MHz 6/ 4.5 dB max –– –– = -20 V, I = 20 mA, 200 MHz min –– –– fT VCE = 6 V, IC = 5 mA, f = 100 MHz Collector Base Time Constant RbCc VCB = 6 V, IE = 2 mA, f = 31.9 MHz 6/ Output Capacitance Cob/cb VCB = 10 V, IE = 0 A, f = 0.1 to 1 MHz Current Gain – Bandwidth Product Input Capacitance Delay Time Rise Time Storage Time Fall Time Cib V C 1.0 GHz min f CE = 100 MHz 4 - 15 ps V = -10 V, IE = 0 A, 1.0 pF max f =CB1.0 MHz 8 pF max –– –– VBE = -2.0 V, IC = 0 A, f = 1.0 MHz 30 pF max t(on) td tr –– –– –– –– VCC = -30 V, IC = 150 mA, IB1 = IB2 = 15 mA 45 ns max t(off) ts tf –– –– –– –– VCC = -6 V, IC = 150 mA, IB1 = IB2 = 15 mA 300 ns max NOTES: * Pulse Test: Pulse Width = 300µsec, Duty Cycle = 2% 1/ For Ordering Information, Price, and Availability Contact Factory. 2/ Screening based on MIL-PRF-19500. Screening flows available 3/ For Package Outlines Contact Factory. 4/ Unless Otherwise Specified, All Electrical Characteristics @25ºC 5/ Mounted on F__ PCB 6/ parameter guaranteed by design on request. Available Part Numbers: SFT85707GW Package Gullwing Pin 1 Collector PNP Pin 2 Base PNP PIN ASSIGNMENT Pin 3 Pin 4 Emitter Collector PNP NPN Pin 5 Base NPN Pin 6 Emitter NPN