VI TELEFILTER Filter specification TFS 408 1/5

Filename: tfs 408.doc
Version 1.5
VI TELEFILTER
11.04.2005
Filter specification
TFS 408
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedances *
for input:
for output:
Coupling coil:
23 °C
0 dBm
790 Ohm || - 1.45 pF
790 Ohm || - 1.45 pF
100 nH
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 408 is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 408,0 MHz without tolerance. The given values for the relative
attenuation arel and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. value
Insertion loss in OTR
Insertion loss in ROTR
ae
Nominal frequency
fN
Centre frequency
fC
Relative attenuation
3,7
3,7
dB
dB
tolerance / limit
max.
max.
408,035
5,5
5,0
408,0
MHz
dB
dB
MHz
-
arel
fN
fN
±
100
kHz
... fN
... fN
±
±
100
150
kHz
kHz
fN
fN
±
±
+
kHz
kHz
MHz
MHz
... fN
... fN
... fN
...
±
±
-
fN
500
700
0,3
4,8
700
4,8
4,8
800
kHz
MHz
MHz
MHz
0,4
2
dB
dB
max.
max.
1,5
3
dB **
dB
30
44
53
55
dB
dB
dB
dB
min.
min.
min.
min.
25
40
45
45
dB
dB
dB
dB
1
µs
max.
2
µs
10
Group delay ripple
fN
±
150
kHz
Input power level
****
-
max.
Operating temperature range
OTR
-
- 40°C ... + 85 °C
Reduced operating temperature range
ROTR
-
0°C ... + 50 °C
-
- 55°C ... + 125 °C
Storage temperature range
Frequency inversion temperature
T0
Temperature coefficient of frequency
TCf ***
***
28
°C
-
-0,038
ppm/K²
-
dBm
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) 1 dB in reduced operating temperature range
***) ∆f(Hz) = TCf(ppm/K) x (T-T0)² x fTo(MHz).
****) also guaranteed 15 dBm for 1 minute over lifetime of filter
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 408.doc
Version 1.5
VI TELEFILTER
11.04.2005
Filter specification
TFS 408
2/5
Filter characteristic
0
0
-10
-1
-20
-2
-30
-3
-50
-60
-4
-5
4.91
-6
delay in µs
-40
7.91
6.41
magnitude in dB
magnitude in dB
9.41
3.41
-70
-7
-80
-8
-90
-9
1.91
0.41
-100
406
406.4 406.8 407.2 407.6 408 408.4 408.8 409.2 409.6
frequency in MHz
-10
410
407.8
407.9
408
408.1
frequency in MHz
408.2
408.3
408.4
Construction and pin connection
(All dimensions in mm)
5
7
S408
● T15
3
7
5
0,1
1,1
120°
+0,15
1,1
Input
Input RF return
External Coil
Ground
External Coil
Output RF return
Output
Ground
Date code:
T
U
V
...
Year + week
2005
2006
2007
1,8 Max.
1
Date cod e
0,64
3
5 - 0,10
1
1
2
3
4
5
6
7
8
2,54
50 Ω Test circuit
L1
1
C1
L2
7
SAW
C2
5
3
2, 4, 6, 8
L3
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 408.doc
Version 1.5
VI TELEFILTER
11.04.2005
Filter specification
TFS 408
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
Tape (all dimensions in mm)
W
: 12,00 ± 0,3
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,1
F
: 5,50 ± 0,05
G(min)
: 0,75
P2
: 2,00 ± 0,05
P1
: 8,00 ± 0,1
D1(min)
: 1,50
Ao
: 5,30 ± 0,1
Bo
: 5,30 ± 0,1
Ct
: 9,5 ± 0,1
t
P1
Date Code
Po
P2
W
G
Ct
Bo
F
G
E
Do
Ko
Typ
PIN Marker
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 12,4 +2/-0
W2(max) : 18,4
N(min)
: 50
C
: 13,0 +0,5/-0,2
A
C
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 408.doc
Version 1.5
VI TELEFILTER
11.04.2005
Filter specification
TFS 408
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 408.doc
VI TELEFILTER
Version 1.5
Filter specification
11.04.2005
TFS 408
5/5
History
Version
Reason of Changes
Name
Date
1.0
- Generation of development specification
Strehl
27.09.2004
1.1
- Increase of operating temperature range
Braun
12.10.2004
1.2
- Changed tolerance scheme according to customer request
Martens
16.11.2004
1.3
- Changed specification according to customer requirement
Martens
02.12.2004
1.4
- Replace single ended coupling coil by balanced coupling coil
- Change pinning
Dr. Wall
23.02.2005
1.5
- Added filter characteristic
- Added typical values
- Change to filter specification
Martens
11.04.2005
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.