DTSPU100 SERIES 100 Watts AC DC Desktop Power Supplies Single Outputs Rev A Size: 5.75in x 2.99in x 1.69in (146mm x 76mm x 43mm) FEATURES • • • • • APPLICATIONS • • • • • • • • • • • Output Voltages Ranging from 11~48VDC Wide Operating Input Voltage of 90~260VAC IEC-320-C14 Input Inlet Single Output Over Voltage, Over Load, and Short Circuit Protection Active Power Factor Correction Efficiency Level VI Compliant RoHS Compliant Class I High Efficiency of 88~89% DESCRIPTION Printer Industrial PC Power Tools DC Moto AV Equipment LED Lighting The DTSPU100 series of AC DC desktop power supplies provides 100 watts of continuous output power. This series consists of single output models with an output voltage ranging from 11-48VDC and an input voltage range of 90~260VAC. All models are protected against over voltage, over load, and short circuit conditions, and have UL/c-UL (UL 60950-1: 2nd Edition) and TUV/GS (EN 60950-1:2nd Edition) safety approvals. This series is Class I and has Energy Efficiency Level VI and RoHS compliance. All units are 100% burn-in tested. MODEL SELECTION TABLE Model Number DTSPU100-105 DTSPU100-106 DTSPU100-107 DTSPU100-108 DTSPU100-109 DTSPU100-110 DTSPU100-111 12/3/2015 Input Voltage Range Output Voltage(1) 90~260VAC 11~13VDC 13~16VDC 16~21VDC 21~27VDC 27~33VDC 33~40VDC 40~48VDC Output Current Min Load Max Load 9.09A 7.96A 7.69A 6.25A 6.25A 4.76A 4.76A 3.70A 3.70A 3.03A 3.03A 2.50A 2.50A 2.08A Ripple & Noise(2) 100mVp-p No Load Output Power Consumption Power 0.21W 100W 100W 100W 100W 100W 100W 100W Total Regulation Efficiency(3) ±5% ±4% ±4% ±4% ±3% ±3% ±3% Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] 88% 88% 88% 89% 89% 89% 89% Page 1 of 5 DTSPU100 SERIES 100 Watts AC DC Desktop Power Supplies Single Outputs Rev A SPECIFICATIONS All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS Min Typ Max Unit INPUT SPECIFICATIONS Safety Approval Input Voltage Range Input Operate Voltage Range Input Voltage Range Input Frequency Power Factor Correction Low Line Input Current High Line Low Line Inrush Current High Line OUTPUT SPECIFICATIONS Output Voltage Line Regulation(4) Load Regulation(5) Output Power Output Current Ripple & Noise (20MHz bandwidth)(2) Transient Response Time Start-Up Time(6) Hold-Up Time(7) Temperature Coefficient PROTECTION Short Circuit Protection Over Load Protection Over Voltage Protection ENVIRONMENTAL SPECIFICATIONS Operating Case Temperature Storage Temperature Operating Humidity Storage Humidity Surge Voltage Electro Static Discharge Vibration Cooling Operating Altitude MTBF GENERAL SPECIFICATIONS Efficiency Dielectric Withstanding Voltage Safety Ground Leakage Current PHYSICAL SPECIFICATIONS Weight Io=Full Load, Vin=240VAC Full Load, Vin=100VAC Full Load, Vin=240VAC Full Load, 25ºC, Cool Start, Vin=100VAC Full Load, 25ºC, Cool Start, Vin=240VAC 100 90 47 0.95 240 260 63 1 1.2 0.5 50 100 VAC Hz A A See Table Full Load, Vin=100~120VAC Vin=230VAC, 10~90% Load Change at Condition 3 1 5 % % 4 2 mS S mS %/ºC See Table See Table See Table Full Load, Vin=110VAC Full Load, Vin=100~240VAC Full Load, Vin=100VAC Full Load, Vin=100~240VAC 16 ±0.04 Recovers automatically after fault condition is removed 110 112 Derate linearly from 100% load at 40ºC to 50% load at 70ºC 10~95% RH Non-Condensing 0 -40 0 0 All Conditions Air Discharge, IEC61000-4-2 Contact Discharge, IEC61000-4-2 10~500Hz, 10min./1 cycle, 60 min. each along X, Y, Z axes All Conditions Operating Temperature at 25ºC, calculated per MIL-HDBK-217F Full Load, Vin=230VAC Primary to Secondary Primary to PE Vin=240VAC, 60Hz Automatic Recovery 150 132 70 85 95 95 2 8 6 5 Free Air Convention 3000 100,000 See Table 4242 2652 0.75 % % ºC ºC % RH % RH kV kV kV G m H VDC mA Approx. 1.08~1.48lbs (490~670g) 5.75in x 2.99in x 1.69in (146mm x 76mm x 43mm) Dimensions (L x W x H) SAFETY & EMC CHARACTERISTICS Safety Approvals(8) Protection Class Flammability Rating EMC Emission 12/3/2015 UL/c-UL (UL 60950-1: 2nd Edition) TUV/GS (EN 60950-1: 2nd Edition) Compliance to EN55022 (CISPR22), EN61000-3-2, 3 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Class I UL94V-1 Class B Page 2 of 5 Rev A DTSPU100 SERIES 100 Watts AC DC Desktop Power Supplies Single Outputs NOTES (1) (2) (3) (4) (5) (6) (7) (8) Setting Voltage Range is the factory setting and cannot be adjusted. Ripple & Noise is measured by using 20MHz bandwidth limited oscilloscope and terminated each output with a 0.47uF capacitor at rated load and nominal line. Efficiency is measured at rated load and nominal line. Line Regulation is defined by changing ±10% of input voltage from nominal line at rated load. Load Regulation is defined by changing ±40% of measured output load from 60% rated load. Output can provide up to peak load when the power supply starts up. Continuous staying in more than rated load is not allowed. Hold up time is measured from the end of the last charging pulse to the time which the main output drops down to low limit of main output at rated load and nominal line. The DTSPU100-108 is available on KC mark (Korea Certification) DERATING CURVES Input Voltage Derating Curve Temperature Derating Curve 12/3/2015 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 3 of 5 Rev A DTSPU100 SERIES 100 Watts AC DC Desktop Power Supplies Single Outputs MECHANICAL DRAWINGS Output Cable Recommended: 1. This series is required to use AWG#16x5C/4FT output cable. 2. The regulation and efficiency will be changed by modified output cable. Optional output connectors available, please contact factory for order details. 12/3/2015 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 4 of 5 Rev A DTSPU100 SERIES 100 Watts AC DC Desktop Power Supplies Single Outputs COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 12/3/2015 (603)778-2300 (888)597-9255 (603)778-9797 [email protected] www.wallindustries.com 37 Industrial Drive Exeter, NH 03833 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 5 of 5