P15VG-xxxxE/Z2:1LF PMN-SERIES Rev. 05-2013 15 Watt 2:1 Input 1” x 1” Case 1.6 kV DC I/O Isolation Reg. Single and Dual Output Remote ON/OFF Control Continuous Short Circuit Prot. Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] The PMN series is a family of high performance 15W single & dual output DC-DC converters. These are encapsulated in nickel coated copper 1” x 1” case with non conductive base. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current1 Start up Time 2:1 Input (see table) Pi-Type 20mA pk-pk 20mS Output Specifications Voltage Accuracy Short Circuit Protection Output Voltage Adjustable (trim) Cross Regulation2 (dual output) Line Regulation Load Regulation (0% - 100%) Ripple and Noise (20Mhz bandwidth) 3 Over Current Protection Transient Recovery4 Transient Response Deviation4 Temperature Coefficient ± 1% Indefinite (hiccup, automatic recovery) ± 10%, max. (only single output) ± 5% ± 0.2%, max. ± 0.5%, max. (single) ± 1%, max. (dual) 100 mV pk-pk, max. 150% of FL 250 us, typ. ± 3%, max. ± 0.02% / °C General Specifications Efficiency I/O Isolation Voltage (3 sec.) Isolation Resistance Isolation Capacity Switching Frequency Humidity Reliability Calculated MTBF (MIL-HDBK-217F) Physical Specifications Case Material Weight Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform See Table 1600 VDC 1000 MOhm, min. 1200 pF, max. 375 kHz, typ. 95% rel H > 560 khrs Nickel Coated Copper ~ 18 g, typ. -40 to +66°C (for 100%) 105°C -40 to +125°C Free Air Convection (10 mm distance required) Soldering 260°C, max. (1.5mm from case 10s.) PMN-Series – P15VG-xxxxE/Z2:1LF – Single and Dual Output – 1”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/4 Selection Guide Single and Dual Output (If you need other specifications, please enquire) Order # A) A) ) ) d (m (mA mA d (m a ( a d o ) o d a L L a C ) )5 o . (uF (VD Min Full o Lo ull L VDC t t d ( e N F n n ) a t g t e e e o r r % ta rren rren ltag or L cy ( Cur Cur Vol t Vo t Cu t Cu acit put put put cien Inpu Inpu Inpu Out Out Out Effi Cap SINGLE OUTPUT P15VG-123R3E2:1LF P15VG-1205E2:1LF P15VG-1212E2:1LF P15VG-1215E2:1LF P15VG-243R3E2:1LF P15VG-2405E2:1LF P15VG-2412E2:1LF P15VG-2415E2:1LF P15VG-483R3E2:1LF P15VG-4805E2:1LF P15VG-4812E2:1LF P15VG-4815E2:1LF 9-18 9-18 9-18 9-18 18-36 18-36 18-36 18-36 36-75 36-75 36-75 36-75 20 20 20 20 15 15 15 15 10 10 10 10 1310 1471 1494 1420 647 727 747 710 327 368 374 359 3.3 5 12 15 3.3 5 12 15 3.3 5 12 15 0 0 0 0 0 0 0 0 0 0 0 0 4000 3000 1300 1000 4000 3000 1300 1000 4000 3000 1300 1000 85 86 88 89 86 87 88 89 85 86 88 88 1000 1000 330 220 1000 1000 330 220 1000 1000 330 220 DUAL OUTPUT P15VG-1205Z2:1LF P15VG-1212Z2:1LF P15VG-1215Z2:1LF P15VG-2405Z2:1LF P15VG-2412Z2:1LF P15VG-2415Z2:1LF P15VG-4805Z2:1LF P15VG-4812Z2:1LF P15VG-4815Z2:1LF 9-18 9-18 9-18 18-36 18-36 18-36 36-75 36-75 36-75 20 20 20 15 15 15 10 10 10 1488 1420 1437 744 718 710 377 363 359 ±5 ± 12 ± 15 ±5 ± 12 ± 15 ±5 ± 12 ± 15 0 0 0 0 0 0 0 0 0 ± 1500 ± 625 ± 500 ± 1500 ± 625 ± 500 ± 1500 ± 625 ± 500 85 89 89 85 88 89 84 87 88 ± 470 ± 220 ± 100 ± 470 ± 220 ± 100 ± 470 ± 220 ± 100 Notes: PMN-Series – P15VG-xxxxE/Z2:1LF – Single and Dual Output – 1”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/4 25.40 (1.00) 20.32 (0.80) Package / Pinning / Derating # 1 2 3 4 5 6 PIN CONNECTION SINGLE DUAL +Vin +Vin - Vin - Vin CTRL CTRL +Vout +Vout Trim Common - Vout - Vout Notes: PMN-Series – P15VG-xxxxE/Z2:1LF – Single and Dual Output – 1”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/4 App Notes 1 = Measured Input reflected ripple current with a simulated source inductance of 12 uH 2 = One load is 25% to 100% load, the other load is 100% load, the output voltage variable rate is within ±5% 3 = Measured with a 1.0uF ceramic capacitor and 10uF tantalum capacitor 4 = Tested by normal Vin and 25% load step change (75% - 50% - 25% of Io) 5 = Tested by minimal Vin and constant resistive load 6 = Input filter components (C1, L, C2) are used to help meet conducted emissions requirement for the module. These components should be mounted as close as possible to the module; and all leads should be minimized to decrease radiated noise 7 = An external filter capacitor is required if the module has to meet EN61000-4-4 and EN61000-4-5 8 = The remote ON/OFF control pin is referenced to -Vin (pin2) C1 L C2 1210, 2.2uF/100V 12uH 1210, 2.2uF/100V P15VG-12xx P15VG-24xx P15VG-48xx EMC SPECIFICATIONS Radiated Emissions Conducted 6 Emissions ESD RS 7 EFT 7 Surge CS PFMF EN 55022 CLASS A EN 55022 CLASS A EN 61000-4-2 EN 61000-4-3 EN 61000-4-4 EN 61000-4-5 EN 61000-4-6 EN 61000-4-8 Perf. Criteria A Perf. Criteria A Perf. Criteria A Perf. Criteria A Perf. Criteria A Perf. Criteria A Rtrim-up Rtrim-down 5 4 6 5 External Output Trimming Output can be externally trimmed. (Single output models only!) Under Input Voltage Lockout (typ.) Over Voltage Protection (Zender diode clamp) 12 Vin Models Module ON/OFF 8.5V / 7V 3.3 Vout: 3.9 V 24 Vin Models Module ON/OFF 17V / 15V 5 Vout 6.2 V 48 Vin Models Module ON/OFF 35V / 34V 12 Vout 15 V 15 Vout 18 V ± 5 Vout ± 6.2 V ± 12 Vout ± 15 V ± 15 Vout ± 18 V Remote ON/OFF Control ON: OFF: OFF idle current: 8 3 -12 VDC or open circuit 0 – 1.2 VDC or short circuit PIN2 and PIN3 5mA, typ. PMN-Series – P15VG-xxxxE/Z2:1LF – Single and Dual Output – 1”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 4/4