P30WG-xxxxE/Z2:1LF Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] PMT-SERIES Rev.11-2009 30 Watt 2:1 Wide Input 2” x 1” Metal Case 1.6 kV DC I/O Isolation Regulated Output Single and Dual Output Continuous Short Circuit Prot. The PMT series P30WG-xxxxE/Z2:1LF is a family of cost effective 30W, single and dual output DC-DC converters with a wide input range of 2:1. These converters are encapsulated in nickel coated brass 2”x1” case with high performance features: 1600VDC input/output isolation voltage, continuous short circuit protection with automatic restart and tight line / load regulation, over current protection, over voltage protection, over temperature protection, high efficiency operation and soft start. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ Start up Time (Nom. Vin and constant resistive load) 2:1 Wide Input (see table) PI Type 20 mA pk-pk 30mS, typ. Output Specifications Voltage Accuracy Voltage Adjustability (only Single Output) Short Circuit Protection Over Load Protection Line Regulation Load Regulation (0% - 100%) Cross Regulation³ Ripple&Noise (20Mhz bandwidth / 1.0uF – pk-pk) Temperature Coefficient Transient Recovery Time4 Transient Response Deviation4 ± 1% ± 10%, max. Indefinite (hiccup, automatic recovery) 150% of FL, typ. ± 0.5%, max. ± 0.5% (single) ±1% (dual balanced load), max. ± 5% (dual) 100 mV, max. ± 0.02% / °C 250us, typ. ± 3%, max. General Specifications I/O Isolation Voltage (3 sec.) I/O Isolation Capacitance I/O Isolation Resistance Switching Frequency Humidity Reliability Calculated MTBF (MIL-HDBK-217F) 1600 VDC 1500 pF, typ. 1000 M Ohm, min. 330 kHz, typ. 95% rel H >435 khrs Physical Specifications Case Material Potting / Base Material Weight Nickel Coated Copper Epoxy / Plastic (UL94V-0 rated) ~ 31g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +50°C (for 100% - ambient) 105°C -40 to +125°C Free Air Convection (10mm distance required) Soldering 260°C, max. (1.5mm from case 10s.) PMT-Series – P30WG-xxxxE/Z 2:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/4 Selection Guide Single and Dual Output Order # ) A) ) ) (mA d (m mA ad (mA d a ( a o ) o d ² C) in. L Loa ull L uF) VDC ll L o (VD nt M nt F ) ad ( ge ( t No rent Fu e e e o a n r r % g t r r L ( l e a r r r lt or Vo Cu Cu cy t Cu put Cu t Vo acit put put put cien Inpu Inpu In Out Out Out Effi Cap SINGLE OUTPUT P30WG-123R3E2:1LF P30WG-1205E2:1LF P30WG-125R1E2:1LF P30WG-1212E2:1LF P30WG-1215E2:1LF P30WG-243R3E2:1LF P30WG-2405E2:1LF P30WG-245R1E2:1LF P30WG-2412E2:1LF P30WG-2415E2:1LF P30WG-483R3E2:1LF P30WG-4805E2:1LF P30WG-485R1E2:1LF P30WG-4812E2:1LF P30WG-4815E2:1LF 9-18 9-18 9-18 9-18 9-18 18-36 18-36 18-36 18-36 18-36 36-72 36-72 36-72 36-72 36-72 80 180 160 30 30 70 100 100 20 40 50 70 70 30 30 2426 2874 2874 2809 2809 1185 1420 1448 1436 1420 593 702 724 718 710 3.3 5 5.1 12 15 3.3 5 5.1 12 15 3.3 5 5.1 12 15 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 8000 6000 6000 2500 2000 8000 6000 6000 2500 2000 8000 6000 6000 2500 2000 89 91 92 91 92 91 92 92 92 92 90 91 91 91 91 20000 14000 14000 2000 2000 20000 14000 14000 2000 2000 20000 14000 14000 2000 2000 DUAL OUTPUT P30WG-1205Z2:1LF P30WG-1212Z2:1LF P30WG-1215Z2:1LF P30WG-2405Z2:1LF P30WG-2412Z2:1LF P30WG-2415Z2:1LF P30WG-4805Z2:1LF P30WG-4812Z2:1LF P30WG-4815Z2:1LF 9-18 9-18 9-18 18-36 18-36 18-36 36-72 36-72 36-72 180 50 50 100 40 50 70 50 40 2874 2874 2874 1437 1453 1437 710 718 718 ±5 ± 12 ± 15 ±5 ± 12 ± 15 ±5 ± 12 ± 15 0 0 0 0 0 0 0 0 0 ± 3000 ± 1250 ± 1000 ± 3000 ± 1250 ± 1000 ± 3000 ± 1250 ± 1000 89 90 91 90 91 91 90 90 90 ± 3000 ± 1300 ± 1300 ± 3000 ± 1300 ± 1300 ± 3000 ± 1300 ± 1300 If you need other specifications, please enquire. Notes: PMT-Series – P30WG-xxxxE/Z 2:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/4 Package / Pinning / Derating 2.54 (0.10) 10.16 10.16 2.54 (0.40) (0.40) (0.10) 4 5 DIA. 1.00 (0.04) 10.16 (0.40) 6 Bottom View AND OUTPUT MODELS 1 2 3 5.08 5.08 10.16 5.08 (0.20) (0.20) (0.40) (0.20) All dimensions are typical in millimeters (inches). - Pin diameter: 1.0 +/-0.05 (0.04 +/-0.002) - Pin pitch tolerance: +/-0.35 (+/-0.014) 2" x - Case tolerance +/-0.5 (+/-0.02) Specification may change without notice. 5.08 (0.20) min. 1" – METAL CASE # 1 2 3 4 5 6 PIN CONNECTIONS SINGLE DUAL +Vin +Vin - Vin - Vin CTRL CTRL +Vout +Vout - Vout COM TRIM - Vout Notes: PMT-Series – P30WG-xxxxE/Z 2:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/4 App Notes 1 = Measured Input reflected ripple current with a simulated source inductance of 12uH. 2 = Tested by minimal Vin and constant resistive load. 3 = Dual: One load is 25% to 100% load, the other load is 100% load, the output voltage variable rate is within ±5%. 4 = Tested by nominal Vin and 25% load step change (75% - 50% - 25% of Io) 5 = The PMT series can meet EN55022 Class A With an external filter in parallel with the input pins. 6 = An external filter capacitor is required if the module has to meet EN61000-4-4 and EN61000-4-5 7 = The remote on/off control pin is referenced to –Vin (Pin2). Single&Dual Models EMI Filter: Input filter components (C1, C3, L) are used to help meet conducted emissions requirement. These components should be mounted as close as possible to the module; all leads should be minimized to decrease radiated noise. C1: 100uF, 100V L: 12uH C3: 1206, 470PF, 2kV EMC SPECIFICATIONS Radiated Emissions Conducted 5 Emissions ESD RS 6 EFT 6 Surge CS PFMF EN 55022 CLASS A EN 55022 CLASS A EN 61000-4-2 EN 61000-4-3 EN 61000-4-4 EN 61000-4-5 EN 61000-4-6 EN 61000-4-8 Perf. Criteria A Perf. Criteria A Perf. Criteria A Perf. Criteria A Perf. Criteria A Perf. Criteria A Over Voltage Protection (Zender diode clamp) External Output Trimming Output can be externally trimmed. (Single output models only!) Rtrim-up Rtrim-down 6 6 5 4 Under Input Voltage Lockout (typ.) 3.3 Vout: 3.9 V 12 Vin Models Module ON/OFF 8.6V / 7.9V 5 Vout 6.2 V 24 Vin Models Module ON/OFF 17.8V / 16V 5.1 Vout 6.2 V 48 Vin Models Module ON/OFF 33.5V / 30.5V 12 Vout 15 V 15 Vout 18 V ± 5 Vout ± 6.2 V ± 12 Vout ± 15 V ON: ± 15 Vout ± 18 V OFF: Remote ON/OFF Control OFF idle current: 7 3 -12 VDC or open circuit 0 – 1.2 VDC or short circuit PIN2 and PIN3 5mA, typ. CTRL Module ON / OFF Positive logic turns on the module during high logic and off during low logic. Ctrl module on/off can be controlled by an external switch between the ctrl terminal and -Vin terminal. The switch can be an open collector or open drain For positive logic if the ctrl feature is not used, please leave the ctrl pin floating. PMT-Series – P30WG-xxxxE/Z 2:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 4/4