Filename: tfs 215a.doc Version 1.3 VI TELEFILTER 26.02.2007 Filter specification TFS 215A 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: External Coil: 23 0 °C dBm 530 Ω || -3,28 pF 530 Ω || -2,58 pF 82 nH Characteristics Remark: The reference level for the relative attenuation arel of the TFS 215A is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 215 MHz without any tolerance. The given values for both the relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value Insertion loss (reference level) ae Nominal frequency fN Centre frequency fC Bandwidth BW 2 dB Relative attenuation arel 400 600 800 1,6 3,0 max. kHz kHz kHz MHz MHz 215,015 MHz fN fN fN fN fN fN ± ± ± ± ± ± 100 600 800 1,6 3,0 30,0 kHz kHz kHz MHz MHz MHz Group delay ripple within PB Operating temperature range OTR Storage temperature range Temperature coefficient of frequency TCf ** MHz ± 75,0 kHz dB max. 2 kHz min. 150 kHz 0,5 45 45 51 52 55 dB dB dB dB dB dB max. min. min. min. min. min. 3 25 35 40 45 53 dB dB dB dB dB dB 0,7 µs max. 1,2 - - 30 °C ... + 85°C - - 40 °C ... + 85°C +25 Frequency inversion temperature dB fN 280 … … … … … … 5 215,0 0,4 Pass band ripple ± ± ± ± ± dB PB Passband fN fN fN fN fN fN 3,4 tolerance / limit -0,04 °C ppm/K dB µs 2 - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆f(Hz) = TCf(ppm/K2) x (T-T0)2 x fTo(MHz) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215a.doc Version 1.3 VI TELEFILTER 26.02.2007 Filter specification TFS 215A 2/5 Filter characteristic 0 0 6.5 6 -10 5.5 -30 -40 4.5 4 3.5 -10 delay in µs 5 -5 magnitude in dB magnitude in dB -20 3 -50 2.5 -60 2 -70 210 211 212 213 214 215 216 frequency in MHz 217 218 219 -15 214.8 220 214.85 214.9 214.95 215 215.05 frequency in MHz 215.1 215.15 1.5 215.2 Construction and pin connection (All dimensions in mm) S ● 215A V09 1 1,4 +/-0,2 +0,2 7,1 - 0,1 0,2 9,1 +-0,1 1 2 3 4 5 6 7 8 9 10 Output Output External Coil Ground Ground Input Input RF Return Ground Ground Ground Date code: T U V ... Year + week 2005 2006 2007 Date cod e 5,08 1 2,54 3 8 1 R 0 ,2 0,8 6 50 Ω test circuit 6 L1 C1 7 1 L2 SAW 2 L4 3 4, 5, 8, 9, 10 C2 L3 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215a.doc Version 1.3 VI TELEFILTER 26.02.2007 Filter specification TFS 215A 3/5 Stability characteristics After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: reel of empty components at start: reel of empty components at start including leader: trailer: 2000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,10 F : 7,50 ± 0,10 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 1,50 Ao : 7,60 ± 0,10 Bo : 9,60 ± 0,10 Ct : 13,5 t P1 Date Code Po P2 W G Ct Bo F G E Do Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 W2(max) : 22,4 N(min) : 50 C : 13,0 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215a.doc Version 1.3 VI TELEFILTER 26.02.2007 Filter specification TFS 215A 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215a.doc VI TELEFILTER Version 1.3 Filter specification 26.02.2007 TFS 215A 5/5 History Version Reason of Changes Name Date 1.0 Generation of development specification Strehl 11.04.2005 1.1 Generation of filter specification Strehl 13.05.2005 1.2 Correct magnitude of relative attenuation Strehl 20.05.2005 1.3 Changed typical value for parabolic temperature coefficient Strehl 26.02.2007 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.