Filename: tfs 464a.doc Version 1.4 VI TELEFILTER 13.09.2006 Filter specification TFS 464A 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 850 Ω || -3,2 pF 920 Ω || -3,1 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS 464A is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fC is the arithmetic mean value of the upper and lower frequencies at the 1dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 464,0 MHz without tolerance. The given values for the relative attenuation arel and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency fC is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fC. Data typ. value ae = amin Insertion loss (reference level) 8,8 Nominal frequency fN - Centre frequency fC 464,05 dB tolerance / limit max. 13,0 464,00 MHz dB MHz - Passband - Pass band ripple 0,35 dB max. 1,0 dB 1dB bandwidth 3,40 MHz min. 3,15 MHz max. 3,75 MHz Relative attenuation fN 200 96 fN 47 fN 3,5 fN + 192 fN + VSWR within PB MHz MHz MHz MHz MHz … … … … … fN fN fN fN fN + + 96 47 3,5 192 200 Group delay arel MHz MHz MHz MHz MHz at fN Operating temperature range OTR dB dB dB dB dB min. min. min. min. min. max. 0,640 µs max. ns max. - Frequency inversion temperature TCf ** 40 50 40 40 30 2:1 0,85 200 dB dB dB dB dB µs ns - 40 °C ... + 85°C - Storage temperature range Temperature coefficient of frequency 70 65 47 44 57 1,5:1 90 Group delay ripple fN ± 1,575 MHz - 45 °C ... + 85°C 30 °C -0,036 ppm/K² *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fcat(MHz). Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 464a.doc Version 1.4 VI TELEFILTER 13.09.2006 Filter specification TFS 464A 2/5 0 0 1.92 -6 -1 1.77 -2 1.62 -3 1.47 -4 1.32 -5 1.17 -6 1.02 -54 -7 0.87 -60 -8 0.72 -9 0.57 -12 -24 magnitude in dB magnitude in dB -18 -30 -36 -42 -48 424 432 440 448 456 464 472 frequency in MHz 480 488 496 delay in µs Filter characteristic 0.42 -10 461 461.6 462.2 462.8 463.4 464 464.6 465.2 465.8 466.4 467 frequency in MHz 504 Construction and pin connection (All dimensions in mm) S 464A ● U37 Date code 1 2 3 4 5 6 7 8 9 10 Ground Ground Ground Output Output Ground Ground Ground Input Input Date code: U V W ... Year + week 2006 2007 2008 50 Ω Test circuit 9 L1 L3 10 5 SAW 4 L6 L4 L5 L2 1, 2, 3, 6, 7, 8 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 464a.doc Version 1.4 VI TELEFILTER 13.09.2006 Filter specification TFS 464A 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,50 ± 0,1 Bo : 7,50 ± 0,1 Ct : 13,5 ± 0,1 P1 Date Code Po Do P2 W G Ct Bo F G E t Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 +2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 464a.doc Version 1.4 VI TELEFILTER 13.09.2006 Filter specification TFS 464A 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 464a.doc VI TELEFILTER Version 1.4 Filter specification 13.09.2006 TFS 464A 5/5 Version Reason of Changes Name Date 1.0 - Generation of development specification Steiner 18.02.2005 1.1 - terminating impedance, typical values and filter characteristic added - matching configuration changed Pfeiffer 04.04.2005 1.2 - terminating impedance corrected Pfeiffer 09.09.2005 1.3 - VSWR limit introduced Steiner 30.09.2005 1.4 - add group delay - change stability characteristics Alawneh 13.09.2006 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.