Filename: tfs 77c.doc Version 1.2 VI TELEFILTER 12.05.2006 Filter specification TFS 77C 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 25 0 °C dBm 70 Ω || -95,6 pF 60 Ω || -106,9 pF Characteristics Remark: The reference level for the relative attenuation arel of the TFS 77C is the minimum of the pass band attenuation. This value is defined as the insertion loss ae. The nominal frequency fN is fixed at 77,8 MHz without any tolerance. The values of relative attenuation arel are guaranteed for the whole operating temperature range. The frequency shift of the filter in the operating temperature range is included in the production tolerance scheme. Data typ. value Insertion loss (reference level) ae 6,6 Nominal frequency fN 77,8 dB tolerance / limit max. MHz Passband PB 10,4 MHz fN Amplitude ripple in PB p-p 0,6 dB max. Relative attenuation arel 0,6 fN - 4,62 MHz … fN fN fN ± ± 6,3 7,1 MHz MHz fN 77,5 MHz ... fN 22,8 MHz ... fN fN 10,2 MHz ... fN fN + 22,2 MHz ... fN fN + Absolute group delay in PB + + + 4,62 22,8 9,8 22,2 50 Group delay ripple in PB Phase linearity in PB MHz MHz MHz MHz MHz p-p p-p 11,0 dB 77,8 MHz ± 4,62 MHz 1 dB dB max. 1 dB 7 24 dB dB min. min. 3 16 dB dB 65 43 41 50 1,04 dB dB dB dB µs min. min. min. min. 45 30 30 40 - dB dB dB dB ns 92 13 ns max. 130 deg max. 15 deg 35 dB Triple transit response suppression 40 dB min. Input / Output return loss 20 dB min. 10 dB max. 23 dBm - Input power level Operating temperature range OTR Storage temperature range Temperature coefficient of frequency TCf *** - -10 °C ... + 75 °C - -35 °C ... + 85 °C -90 ppm/K - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) Target is 10 dB min. using resistive matching. ***) ∆fc(Hz) = TCf(ppm/K) x (T - To) x fTo (MHz). Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 77c.doc Version 1.2 VI TELEFILTER 12.05.2006 Filter specification TFS 77C 2/5 0 1.78 -0.6 1.69 -14 -1.2 1.6 -21 -1.8 1.51 -28 -2.4 1.42 -3 1.33 -3.6 1.24 -49 -4.2 1.15 -56 -4.8 1.06 -63 -5.4 0.97 -35 -42 -70 32.8 41.8 50.8 59.8 68.8 77.8 86.8 frequency in MHz 95.8 104.8 113.8 -6 71.8 122.8 73 74.2 75.4 76.6 77.8 79 frequency in MHz 80.2 81.4 82.6 delay in µs 0 -7 magnitude in dB magnitude in dB Filter characteristic 0.88 83.8 Construction and pin connection (All dimensions in mm) TFS 77C ● U19 6,8Max. 13,6Max. 2,54 ±0,15 1,5 2,54 ±0,15 1 2 3 4 2,0Max. 1 12 5 11 6 Date code 1 2 3 4 5 6 7 8 9 10 11 12 Ground Ground Ground Ground Output Output RF Return Ground Ground Ground Ground Input Input RF Return Date code: U V W ... Year + week 2006 2007 2008 10 9 8 7 0,1 0,8 50 Ohm Test circuit 11 L1 12 5 SAW L2 L3 6 L4 1, 2, 3, 4, 7, 8, 9, 10 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 77c.doc Version 1.2 VI TELEFILTER 12.05.2006 Filter specification TFS 77C 3/5 Stability characteristics After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: 1700 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction P1 Tape (all dimensions in mm) W : 24,00 +0,30/-0,10 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,10 F : 11,50 ± 0,10 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 1,50 Ao : 7,10 ± 0,10 Bo : 13,90 ± 0,10 Ct : 21,5 ± 0,1 t Po P2 W G Ct Bo F G E Do PIN Marker Ko Date Code Typ D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 24,4 +2/-0 W2(max) : 30,4 N(min) : 60 C : 13,0 +0,5/-0,2 C A N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 77c.doc Version 1.2 VI TELEFILTER 12.05.2006 Filter specification TFS 77C 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 77c.doc VI TELEFILTER Version 1.2 Filter specification 12.05.2006 TFS 77C 5/5 History Version Reason of Changes Name Date 1.0 - Generation of development specification Strehl 23.08.2005 1.1 - changed insertion loss - changed relative attenuation - changed return loss - changed operating temperature range Chilla 08.11.2005 1.2 - created filter specification - changed relative attenuation Chilla 12.05.2006 - added termination impedances - added typical values - added filter characteristics - added test circuit Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.