SUBMINIATURE SOLID STATE LAMP KM2520SRC09 SUPER BRIGHT RED Features Description !SUBMINIATURE PACKAGE. The Super Bright Red source color devices are made !WIDE VIEWING ANGLE. with Gallium Aluminum Arsenide Red Light Emitting !Z-BEND Diode. LEAD. !LONG LIFE - SOLID STATE RELIABILITY. !LOW PACKAGE PROFILE. !PACKAGE : 1000PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: DSAA9883 APPROVED:J.LU REV NO: V.2 CHECKED:Allen Liu DATE:FEB/16/2003 DRAWN:S.J.HOU PAGE: 1 OF 4 Selection Guide P ar t N o . Dic e KM2520SRC09 Iv (m c d ) @ 20 m A L en s Ty p e SUPER BRIGHT RED (GaAlAs) WATER CLEAR V i ew i n g An g l e Min . Ty p . 2θ1/2 110 600 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°°C Sy m b o l P ar am et er λpeak λD ∆λ1/2 D ev i c e Ty p . Peak Wavelength Super Bright Red Dominate Wavelength Un its Tes t Co n d it io n s 660 nm IF = 2 0 m A Super Bright Red 640 nm IF = 2 0 m A Spectral Line Half-width Super Bright Red 20 nm IF = 2 0 m A pF V F = 0 V;f= 1 M Hz 2.5 V IF = 2 0 m A 10 uA VR = 5V C Capacitance Super Bright Red 45 VF Forward Voltage Super Bright Red 1.85 IR Reverse Current Super Bright Red Max . Absolute Maximum Ratings at TA=25°°C P ar am et er S u p er B r i g h t R ed Un its Power dissipation 100 mW DC Forward Current 30 mA Peak Forward Current [1] 155 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA9883 APPROVED:J.LU REV NO: V.2 CHECKED:Allen Liu DATE:FEB/16/2003 DRAWN:S.J.HOU PAGE: 2 OF 4 Super Bright Red SPEC NO: DSAA9883 APPROVED:J.LU KM2520SRC09 REV NO: V.2 CHECKED:Allen Liu DATE:FEB/16/2003 DRAWN:S.J.HOU PAGE: 3 OF 4 KM2520SRC09 SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAA9883 APPROVED:J.LU REV NO: V.2 CHECKED:Allen Liu DATE:FEB/16/2003 DRAWN:S.J.HOU PAGE: 4 OF 4