3.5x2.8 mm SMD CHIP LED LAMP APED3528SGC SUPER BRIGHT GREEN Features Description !SINGLE COLOR. The Super Bright Green source color devices are ! SUITABLE made with Gallium Phosphide Green Light Emitting FOR ALL SMT ASSEMBLY AND !SOLDER PROCESS. Diode. !IDEAL FOR BACKLIGHTING. ! AVAILABLE !PACKAGE ON TAPE AND REEL. : 500PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.0079") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAD1063 APPROVED : J. Lu REV NO: V.1 CHECKED : Allen Liu DATE:MAR/18/2003 DRAWN: L.ZHANG PAGE: 1 OF 4 Selection Guide Par t No . Dic e APED3528SGC Iv (m c d ) @ 20 m A L en s Ty p e SUPER BRIGHT GREEN (GaP) WATER CLEAR V i ew i n g An g l e Min . Ty p . 2θ1/2 18 40 40° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at T)=25°°C Sy m b o l Par am et er λpeak Peak Wavelength Super Bright Green λD Dominate Wavelength ∆λ1/2 D ev i c e Ty p . Un it s Tes t Co n d it io n s 565 nm I F =20mA Super Bright Green 568 nm I F =20mA Spectral Line Half-width Super Bright Green 30 nm I F =20mA pF VF=0V;f=1MHz 2.5 V I F =20mA 10 uA V R = 5V C Capacitance Super Bright Green 15 VF Forward Voltage Super Bright Green 2.2 IR Reverse Current Super Bright Green Max . Absolute Maximum Ratings at T)=25°°C P ar am e t e r Su p er B r ig h t Gr een Un it s Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1063 APPROVED : J. Lu REV NO: V.1 CHECKED : Allen Liu DATE:MAR/18/2003 DRAWN: L.ZHANG PAGE: 2 OF 4 Super Bright Green SPEC NO: DSAD1063 APPROVED : J. Lu APED3528SGC REV NO: V.1 CHECKED : Allen Liu DATE:MAR/18/2003 DRAWN: L.ZHANG PAGE: 3 OF 4 APED3528SGC SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAD1063 APPROVED : J. Lu REV NO: V.1 CHECKED : Allen Liu DATE:MAR/18/2003 DRAWN: L.ZHANG PAGE: 4 OF 4