Filename: tfs 186a.doc Version 1.3 VI TELEFILTER 17.07.2006 Filter specification TFS 186A 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 25 0 °C dBm 797 Ω || -7,2 pF 564 Ω || -7,2 pF Characteristics Remark: The reference level for the relative attenuation arel of the TFS 186A is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 20 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 186,0 MHz without any tolerance. The given values for both the relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value Insertion loss (reference level) ae 6,8 Nominal frequency fN - Centre frequency fC Passband PB Pass band ripple (p-p) Relative attenuation fC fC ± 97 fC fC fC ± ± ± 320 350 20 dB max. MHz - 8 dB 186,0 MHz ± 15,0 kHz fC ± 97,0 kHz 0,2 dB max. 0,5 dB 0,2 0,5 dB dB max. max. 0,5 3 dB dB 27 33 65 dB dB dB min. min. min. 20 30 50 dB dB dB 180 ns max. 250 ns arel … fC … fC ± ± 97 100 kHz kHz kHz kHz … fC MHz … fC ± ± 20 150 MHz MHz kHz 186,0 tolerance / limit Group delay ripple within PB Input power level Operating temperature range OTR max. 20 ** - - 0 °C ... + 80°C Operable temperature range - -10 °C …+ 80°C Storage temperature range - - 40 °C ... + 85°C Frequency inversion temperature Temperature coefficient of frequency TCf *** 46 °C -0,036 ppm/K dBm 2 *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) 28 dBm for 500 hours ***) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 186a.doc Version 1.3 VI TELEFILTER 17.07.2006 Filter specification TFS 186A 2/5 0 5.34 -1 5.13 -12 -2 4.92 -18 -3 4.71 -24 -4 4.5 -5 4.29 -6 4.08 -42 -7 3.87 -48 -8 3.66 -54 -9 3.45 -30 -36 -60 161.7 166.56 171.42 176.28 181.14 186 190.86 frequency in MHz 195.72 200.58 205.44 -10 185.75 210.3 185.8 185.85 185.9 185.95 186 186.05 frequency in MHz 186.1 186.15 186.2 delay in µs 0 -6 magnitude in dB magnitude in dB Filter characteristic 3.24 186.25 Construction and pin connection (All dimensions in mm) 10 +0,20 6,50 - 0,10 6 TFS 186A ● U29 5 Date code 1,02 2,31 1 +0,20 19 - 0,10 2,0 Max. 1 1 2 3 4 5 6 7 8 9 10 Input Ground Ground Ground Output RF Return Output Ground Ground Ground Input RF Return Date code: U V W ... Year + week 2006 2007 2008 1,91 7,62 50 Ω Test circuit L1 1 10 6 SAW L2 5 C2 C1 2, 3, 4, 7, 8, 9 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 186a.doc Version 1.3 VI TELEFILTER 17.07.2006 Filter specification TFS 186A 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: Pull Off Direction Po Date Code P1 P2 Ao Ct Bo So Do E t Ko W Tape (all dimensions in mm) W : 32,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 14,20 ± 0,1 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 2,00 Ao : 7,10 ± 0,1 Bo : 19,60 ± 0,1 So : 28,40 ± 0,1 Ct : 25,5 ± 0,1 2000 min. 300 mm min. 500 mm min. 300 mm Type Reel (all dimensions in mm) A : 330 W1 : 32,4 +2/-0 W2(max) : 38,4 N(min) : 100 C : 13,0 +0,5/-0,2 PIN Marker D1 W2 C A N W1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 186a.doc Version 1.3 VI TELEFILTER 17.07.2006 Filter specification TFS 186A 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 186a.doc VI TELEFILTER Version 1.3 Filter specification 17.07.2006 TFS 186A 5/5 History Version Reason of Changes Name Date 1.0 - Generation of development specification Strehl 18.04.2006 1.1 - add of terminating impedances (preliminary values), filter characteristic and matching configuration Pfeiffer 24.05.2006 1.2 - change off centre frequency Pfeiffer 06.07.2006 1.3 - correction of terminating impedances and filter characteristics Pfeiffer 17.07.2006 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.