3.5x2.8 mm SMD CHIP LED LAMP AA3528SEC SUPER BRIGHT ORANGE Features Description !SINGLE COLOR. The Super Bright Orange source color devices are ! SUITABLE made with DH InGaAlP on GaAs substrate Light FOR ALL SMT ASSEMBLY AND SOLDER PROCESS. Emitting Diode. !IDEAL FOR BACKLIGHTING. ! AVAILABLE !PACKAGE ON TAPE AND REEL. : 1500PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAD1229 APPROVED: J.Lu REV NO: V.1 CHECKED: Allen Liu DATE: MAR/27/2003 DRAWN: K.ZHANG PAGE: 1 OF 4 Selection Guide Par t No . Dic e A A 3528S E C Iv (m c d ) @ 20 m A L en s Ty p e SUPER BRIGHT ORANGE (InGaAlP) WATER CLEAR V i ew i n g An g l e Min . Ty p . 2θ1/2 180 35 0 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at T)=25°°C Sy m b o l Par am et er λpeak Peak Wavelength Super Bright Orange λD Dominate Wavelength Super Bright Orange ∆λ1/2 D ev i c e Spectral Line Half-width Super Bright Orange Ty p . Un it s Tes t Co n d it io n s 6 10 nm I F =20mA 601 nm I F =20mA 29 nm I F =20mA pF VF=0V;f=1MHz 2.5 V I F =20mA 10 uA V R = 5V C Capacitance Super Bright Orange 30 VF Forward Voltage Super Bright Orange 2.0 IR Reverse Current Super Bright Orange Max . Absolute Maximum Ratings at T)=25°°C P ar am e t e r Su p er B r ig h t Or an g e Un it s Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1229 APPROVED: J.Lu REV NO: V.1 CHECKED: Allen Liu DATE: MAR/27/2003 DRAWN: K.ZHANG PAGE: 2 OF 4 Super Bright Orange SPEC NO: DSAD1229 APPROVED: J.Lu AA3528SEC REV NO: V.1 CHECKED: Allen Liu DATE: MAR/27/2003 DRAWN: K.ZHANG PAGE: 3 OF 4 AA3528SEC SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAD1229 APPROVED: J.Lu REV NO: V.1 CHECKED: Allen Liu DATE: MAR/27/2003 DRAWN: K.ZHANG PAGE: 4 OF 4