, One. <3E.ml-tondu.ct oi 20 STERN AVE. SPRINGFIELD, NEW JERSEY 07081 U.S.A. TELEPHONE: (973) 376-2922 (212)227-6005 FAX: (973) 376-8960 2N3402 - 5 2N3414 - 7 absolute maximum ratings: (25°C) (unless otherwise specified) 2N3402.3 2N3414.15 2N3404.5 2N3416.17 Veltagei Collector to Emitter Emitter to Base VCBO V EB o Collectbr to Base Current VCBO Collector (Steady State)* Ic Diitipation 25 5 25 500 ma 900 5(iO tnw mw 300 260 (2N3414-17) Temperature T.,, T, 50 V 500 Heatsink @ 25°C (2N3402-5) •* PT Total Power (Free Air @ 25°C)t PT (2N3402-5) Total Power (Free Air @ 25°C)1 PT (2N3414-17) Total Power (Free Air @ 65°C)1 PT Storage Operating Lead Soldering, Mil" ± VM" from case for 10 seconds max. 60 V 5 V -55 to +150 + 150 'C + 260 °C 'Determined from power limitations due to saturation voltage at this current, •Derate 7.2 m\v/°C increase in case temperature above 25°C. fDerate 4.47 m\v/"C increase in ambient temperature above 2S"C. IDerate 2.67 mw/°C increiise in a m b i e n t temperature above 25"C. electrical characteristics: (26°C) DC CHARACTERISTICS Collector Cutoff Current ( VCB - 26V) (VcB = 25V, T* = 100°C) Collector Cutoff Current (V C B = 60V) (VcB = 50V, TA = 100'C) Emitter Cutoff Current (V E n = 5V) Collector Saturation Voltage (IB = 3 ma, Ic = 50 ma) Ba«e Joturation Voltage (IB = 3 ma, Ic = 50 ma) 2N3404.5 2N3416.7 2N3402.3 2N3414,5 (unless otherwise specified) Max. Min. Min. 15 0.1 0.1 O.L o.uo 0.30 0.85 Min. 76 SMALL SIGNAL CHARACTERISTICS Forward Current Tromfer Ratio Collector Voltage, 75 2N3402 Vt — 4.5V, Frequency of measurement = 1000 cps VCE = 10V; Ic = 1 ma; f = 1 Kc; T A = 25°C Forward Current Tranifer Ratio Input Impedance Output Admittance Voltage Feedback Ratio h,. h,. h.. hr. MB 15 0.85 2N3403.5 2N3415.7 2N3402.4 2N3414.6 Forward Current Tron.fer Ratio (Vet = 4.5V, Ic = 2 ma) Max. 0.1 ICBO ICBO ICBO ICBO luno V < K ,SAT> VRKISAT, 180 5100 14 .27 Max. Min. Max. 225 180 540 2N3403 180 2N3404 2N3-1IS 2N3405 330 9000 21 ,45 150 4200 10 .2 300 8300 20 .4 ohms /imhos X 10-' NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions without notice. Information furnished by NJ Semi-Conductors is believed to be both accurate and reliable at the time of going to press. However, NJ Semi-Conductors assumes no responsibility for any errors or omissions discovered in its use. NJ Semi-Conductors encourages customers to verify that datasheets are current before placing orders. Quality Semi-Conductors