BD249, BD249A, BD249B, BD249C NPN SILICON POWER TRANSISTORS ● Designed for Complementary Use with the BD250 Series ● 125 W at 25°C Case Temperature ● 25 A Continuous Collector Current ● 40 A Peak Collector Current ● Customer-Specified Selections Available SOT-93 PACKAGE (TOP VIEW) B 1 C 2 E 3 Pin 2 is in electrical contact with the mounting base. MDTRAAA absolute maximum ratings at 25°C case temperature (unless otherwise noted) RATING SYMBOL Collector-emitter voltage (RBE = 100 Ω) E T E L O S B O Collector-emitter voltage (IC = 30 mA) BD249B VCER 70 90 BD249C 115 BD249 45 BD249A BD249B UNIT 55 BD249 BD249A VALUE V CEO BD249C 60 80 V V 100 VEBO 5 V IC 25 A ICM 40 A IB 5 A Continuous device dissipation at (or below) 25°C case temperature (see Note 2) Ptot 125 W Continuous device dissipation at (or below) 25°C free air temperature (see Note 3) Ptot 3 W ½LIC2 90 mJ Tj -65 to +150 °C Tstg -65 to +150 °C TL 250 °C Emitter-base voltage Continuous collector current Peak collector current (see Note 1) Continuous base current Unclamped inductive load energy (see Note 4) Operating junction temperature range Storage temperature range Lead temperature 3.2 mm from case for 10 seconds NOTES: 1. 2. 3. 4. This value applies for tp ≤ 0.3 ms, duty cycle ≤ 10%. Derate linearly to 150°C case temperature at the rate of 1 W/°C. Derate linearly to 150°C free air temperature at the rate of 24 mW/°C. This rating is based on the capability of the transistor to operate safely in a circuit of: L = 20 mH, IB(on) = 0.4 A, RBE = 100 Ω, VBE(off) = 0, RS = 0.1 Ω, VCC = 20 V. JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice. 1 BD249, BD249A, BD249B, BD249C NPN SILICON POWER TRANSISTORS electrical characteristics at 25°C case temperature PARAMETER V(BR)CEO ICES ICEO IEBO hFE V CE(sat) VBE hfe |hfe | Collector-emitter breakdown voltage TEST CONDITIONS IC = 30 mA MIN IB = 0 (see Note 5) BD249 45 BD249A 60 BD249B 80 BD249C 100 TYP MAX V VCE = 55 V VBE = 0 BD249 0.7 Collector-emitter VCE = 70 V VBE = 0 BD249A 0.7 cut-off current VCE = 90 V VBE = 0 BD249B 0.7 VCE = 115 V VBE = 0 BD249C 0.7 Collector cut-off VCE = 30 V IB = 0 BD249/249A 1 current VCE = 60 V IB = 0 BD249B/249C 1 VEB = 5V IC = 0 Emitter cut-off current Forward current transfer ratio 1 VCE = 4V IC = 1.5 A VCE = 4V IC = 15 A VCE = 4V IC = 25 A Collector-emitter IB = 1.5 A IC = 15 A saturation voltage IB = 5A IC = 25 A Base-emitter voltage Small signal forward current transfer ratio Small signal forward current transfer ratio 4V IC = 15 A 4V IC = 25 A mA mA mA 25 (see Notes 5 and 6) 10 5 1.8 (see Notes 5 and 6) 4 E T E L O S B O VCE = VCE = UNIT 2 (see Notes 5 and 6) VCE = 10 V IC = 1A f = 1 kHz 25 VCE = 10 V IC = 1A f = 1 MHz 3 4 V V NOTES: 5. These parameters must be measured using pulse techniques, tp = 300 µs, duty cycle ≤ 2%. 6. These parameters must be measured using voltage-sensing contacts, separate from the current carrying contacts. thermal characteristics MAX UNIT RθJC Junction to case thermal resistance PARAMETER MIN TYP 1 °C/W RθJA Junction to free air thermal resistance 42 °C/W MAX UNIT resistive-load-switching characteristics at 25°C case temperature PARAMETER † TEST CONDITIONS † MIN ton Turn-on time IC = 5 A IB(on) = 0.5 A IB(off) = -0.5 A 0.3 µs toff Turn-off time VBE(off) = -5 V RL = 5 Ω tp = 20 µs, dc ≤ 2% 0.9 µs Voltage and current values shown are nominal; exact values vary slightly with transistor parameters. 2 TYP JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice. BD249, BD249A, BD249B, BD249C NPN SILICON POWER TRANSISTORS TYPICAL CHARACTERISTICS TYPICAL DC CURRENT GAIN vs COLLECTOR CURRENT TCS635AD VCE = 4 V TC = 25°C tp = 300 µs, duty cycle < 2% 100 10 1 0·1 1·0 TCS635AB 10 VCE(sat) - Collector-Emitter Saturation Voltage - V hFE - DC Current Gain 1000 COLLECTOR-EMITTER SATURATION VOLTAGE vs BASE CURRENT 1·0 0·1 E T E L O S B O 10 100 IC = 300 mA IC = 1 A IC = 3 A 0·01 0·001 0·01 IC - Collector Current - A 0·1 10 25 A 20 A 15 A 10 A 100 IB - Base Current - A Figure 1. Figure 2. BASE-EMITTER VOLTAGE vs COLLECTOR CURRENT 2·0 1·8 VBE - Base-Emitter Voltage - V 1·0 IC = IC = IC = IC = TCS635AC VCE = 4 V TC = 25°C 1·6 1·4 1·2 1·0 0·8 0·6 0·1 1·0 10 100 IC - Collector Current - A Figure 3. JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice. 3 BD249, BD249A, BD249B, BD249C NPN SILICON POWER TRANSISTORS MAXIMUM SAFE OPERATING REGIONS MAXIMUM FORWARD-BIAS SAFE OPERATING AREA IC - Collector Current - A 100 SAS635AB tp = 300 µs, d = 0.1 = 10% tp = 1 ms, d = 0.1 = 10% tp = 10 ms, d = 0.1 = 10% DC Operation 10 1·0 0·1 BD249 BD249A BD249B BD249C E T E L O S B O 0·01 1·0 10 100 1000 VCE - Collector-Emitter Voltage - V Figure 4. THERMAL INFORMATION MAXIMUM POWER DISSIPATION vs CASE TEMPERATURE TIS635AA Ptot - Maximum Power Dissipation - W 140 120 100 80 60 40 20 0 0 25 50 75 100 125 150 TC - Case Temperature - °C Figure 5. 4 JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice.