TFS199D

Filename: tfs 199d.doc
Version 4.1
VI TELEFILTER
22.09.2005
Filter specification
TFS 199D
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
20...25
°C
5 ± 2 dBm
740 Ω || -7.9 pF single ended
880 Ω || -6.2 pF single ended
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 199D is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 0,5 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 199 MHz without any tolerance. The given values for both the
relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. value
Insertion loss
(reference level)
ae
Nominal frequency
fN
-
100
kHz
max.
-
7,0
199,0
dB
MHz
arel
Relative attenuation
fN
tolerance / limit
… fN
+
100
kHz
-
max.
fN 80
MHz
30
MHz
fN 600
kHz
fN ±
800
kHz
fN +
17
MHz
fN +
Group delay ripple
…
…
…
…
…
fN
fN
fN
fN
fN
±
+
+
30
800
800
17
80
GD
MHz
kHz
kHz
MHz
MHz
-
min.
min.
min.
min.
min.
30
25
20
25
35
dB
dB
dB
dB
dB
fC 100
kHz
Input power level
… fC
+
100
kHz
-
max.
500
ns
-
max.
max.
max.
+18
+10
10
dB
dB
V
-
- 35 °C ... + 85 °C
short test
standard operation
Permissible DC voltage
Operating temperature range
OTR
-
Storage temperature range
Frequency inversion temperature
Temperature coefficient of frequency
TCf **
0,5
dB
- 35 °C ... + 85 °C
23
°C
-0,036
ppm/K
2
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/K2) x (T-T0)2 x fTo(MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 199d.doc
Version 4.1
VI TELEFILTER
22.09.2005
Filter specification
TFS 199D
2/5
0
5
-1
4.6
-20
-2
4.2
-30
-3
3.8
-40
-4
3.4
-5
3
-6
2.6
-70
-7
2.2
-80
-8
1.8
-90
-9
1.4
-50
-60
-100
197
197.4
197.8
198.2
198.6
199
199.4
frequency in MHz
199.8
200.2
200.6
-10
198.5
201
198.6
198.7
198.8
198.9
199
199.1
frequency in MHz
199.2
199.3
199.4
delay in µs
0
-10
magnitude in dB
magnitude in dB
Filter characteristic
1
199.5
Construction and pin connection
(All dimensions in mm)
1
10
1,0±0,2
5
1,91±0,2
7,62±0,2
6
Date code
1,9±0,2
TFS 199D
●
T39
1,8±0,2
6,5 ±0,2
13,3 ±0,2
1
2
3
4
5
6
7
8
9
10
Input RF Return
Ground
Ground
Ground
Output
Output RF Return
Ground
Ground
Ground
Input
Date code:
T
U
V
...
Year + week
2005
2006
2007
50 Ω Test circuit
10
L1
L2
1
5
SAW
L3
6
L4
2, 3, 4, 7, 8, 9
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 199d.doc
Version 4.1
VI TELEFILTER
22.09.2005
Filter specification
TFS 199D
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
1700
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
Tape (all dimensions in mm)
W
: 24,00 +0,30/-0,10
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/0
E
: 1,75 ± 0,10
F
: 11,50 ± 0,10
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 12,00 ± 0,1
D1(min)
: 1,50
Ao
: 7,10 ± 0,10
Bo
: 13,90 ± 0,10
Ct
: 21,5 ± 0,1
P1
t
Po
PIN Marker
P2
W
G
Ct
Bo
F
G
E
Do
Ko
Date Code
Typ
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 24,4 +2/-0
W2(max) : 30,4
N(min)
: 60
C
: 13,0 +0,5/-0,2
A
C
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 199d.doc
Version 4.1
VI TELEFILTER
22.09.2005
Filter specification
TFS 199D
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 199d.doc
VI TELEFILTER
Version 4.1
Filter specification
22.09.2005
TFS 199D
5/5
History
Version
Reason of Changes
Name
Date
1.0
2.0
Steiner
Steiner
05.11.1999
16.06.2000
3.0
-generation of specification
- change to single ended pinning
- new impedances according to single ended design
- change attenuation from 30 dB to 25 dB at
fN- 30MHz...fN-800kHz
fN+800kHz...fN+17MHz
- change the filter name to TFS199D
Steiner
04.07.2000
3.1
- correct the package dimensions
Steiner
28.07.2000
4.0
- change the insertion loss limit from max. 8dB to max. 7dB as agreed
with the customer
Steiner
15.02.2001
4.1
- change packing
Strehl
22.09.2005
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.