RF SAW Filter Part Number Package Application Last Modified 805-RF315.0M-A 5.0 x 5.0 SMD Remote Control Mar. 10, 2007 . TYPE : RF SAW Filter for Remote Control PART NUMBER : 805-RF315.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 315.0 - MHz 314.82 ~ 315.22 MHz ILmin - 2.0 4.0 dB 10.0 ~270.0 MHz 45 55 - 270.0 ~309.0 MHz 30 35 - 309.0 ~313.94 MHz 15 20 - 316.0 ~335.0 MHz 10 15 - dB 335.0 ~400.0 MHz 35 45 400.0 ~1000.0 MHz 45 55 - 322.0 ~ 328.6 MHz- - 0.8 1.5 MHz Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm DC Voltage - - - 10 V 1.5 3.0 dB Ripple in Passband (relative to llmin) - 314.77 ~315.2 MHz - 314.71 ~315.26 MHz - - - 2.0 6.0 dB 3dB Passband Width (relative to llmin) - 0.8 0.92 - MHz Operating Temperature - -40 - +105 ºC * With Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B Ground C Ground D Ground E Out F Ground G Ground H Ground FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF315.0M-A