Filename: tfs 168c.doc Version 1.1 Vectron International 03.12.2008 Filter specification TFS 168C 1/5 vMeasurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 25 0 °C dBm 83 Ω || -30,3 pF 53 Ω || -38,7 pF Characteristics Remark: The nominal frequency fN is fixed at 168,96 MHz. The insertion loss ae is defined as loss value determined at fN. Reference level for the relative attenuation arel of the TFS 168C is the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. All specified data are met within the operating temperature range. Data typ. value ae = amin Insertion loss (reference level) fN - PB 14 Nominal frequency Passband p-p Pass band ripple fN fN fN fN fN ± ± ± ± ± 7,5 17,5 21,5 25,5 66,0 MHz MHz MHz MHz MHz dB max. 20,5 dB 168,96 MHz 6,67 MHz MHz fN 0,4 dB max. 1 dB ± arel Relative attenuation fN 17,8 tolerance / limit … fN ± 6.67 MHz 0,5 dB max. 1 dB … … … … … ± ± ± ± ± 17,5 21,5 25,5 66,0 111,0 MHz MHz MHz MHz MHz 2,5 55 52 49 62 dB dB dB dB dB min. min. min. min. min. 2 40 40 40 40 dB dB dB dB dB max. 120 ns fN fN fN fN fN 35 Group delay ripple within PB Phase linearity within fN - 5 MHz … - 1,92 MHz rms 0,5 deg max. 2 deg Phase linearity within fN ± 1,92 MHz rms 0,5 deg max. 1 deg Phase linearity within fN + 1,92 MHz …+ 5 MHz rms 0,5 deg max. 1,5 deg Operating temperature range OTR Storage temperature range Temperature coefficient of frequency TCf ** - +25 °C ... + 85°C - - 45 °C ... + 85°C -18 ppm/K - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆f(Hz) = TCf(ppm/K) x (T-T0) x fcat(MHz). Generated: Checked / Approved: Vectron International GmbH & Co. KG Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] Vectron International GmbH & Co. KG reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 168c.doc Version 1.1 Vectron International 03.12.2008 Filter specification TFS 168C 2/5 Filter characteristic 0 0 -10 1.35 -1 -30 -40 -2 1.15 delay in µs magnitude in dB magnitude in dB -20 -3 0.95 -50 -4 -60 0.75 -70 79 97 115 133 151 169 187 frequency in MHz 205 223 241 -5 161 259 163 165 167 169 171 frequency in MHz 173 175 177 Construction and pin connection (All dimensions in mm) 5,0Max. 8 9 10 9,3 Max. 6 7 TFS 168C ● W49 2 4 3 Date code Ground Ground Ground Output Output RF Return Ground Ground Ground Input Input RF Return Date code: U V W ... Year + week 2006 2007 2008 2,54 ±0,12,54 ±0,1 0,10 ° 60 1 2 3 4 10 9 5 8 7 0,8 7,1 2,8 2,54 ±0,1 1,8 Max. 1 5 1 2 3 4 5 6 7 8 9 10 6 50 Ohm Test circuit L1 9 10 4 SAW L2 5 C2 C1 1, 2, 3, 7, 8 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 168c.doc Version 1.1 Vectron International 03.12.2008 Filter specification TFS 168C 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction P1 Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,30 ± 0,1 Bo : 9,70 ± 0,1 Ct : 13,5 ± 0,1 Date Code Po Do P2 W G Ct Bo F G E t Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 +2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0 +0,5/-0,2 C A N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 168c.doc Version 1.1 Vectron International 03.12.2008 Filter specification TFS 168C 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 168c.doc Vectron International Version 1.1 Filter specification 03.12.2008 TFS 168C 5/5 History Version Reason of Changes Name Date 1.0 - Generation of development specification Strehl 14.12.2006 1.1 - Created Filter specification - Added terminating impedance - Added typical values - Changed operating temperature range - Added filter characteristic - Added filter test circuit Chilla 03.12.2008 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.