TFS140AS

Filename: tfs 140as.doc
Version 1.6
VI TELEFILTER
30.09.2009
Filter specification
TFS 140AS
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
25
0
°C
dBm
230 Ω || -12 pF
170 Ω || -15 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 140AS is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 20 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 140,0 MHz without any tolerance. The shift of the filter band
width in the operating temperature range (OTR) is included in the production tolerance scheme.
Data
typ. value
Insertion loss
(reference level)
ae
Nominal frequency
fN
-
Centre frequency
fC
140,0
PB
12,1
dB
tolerance / limit
max.
MHz
-
fC
13,5
dB
140,0
MHz
±
0,4
MHz
±
10
MHz
Pass band ripple
0,3
dB
max.
1
dB
Pass band variation
1
dB
max.
1,5
dB
23,8
24,4
MHz
MHz
min.
min.
19,12
20
MHz
MHz
0,3
0,4
45
43
dB
dB
dB
dB
max.
max.
min.
min.
1
1,5
42
40
dB
dB
dB
dB
55
ns
max.
70
ns
600
ns
max
825
ns
deg
max.
10
deg
10
dBm
Passband
BW
Bandwidth
1
dB
1,5 dB
Relative attenuation
fC
fC
fC
fC
±
+
9,56
130,0
17,2
…
MHz ...
MHz ...
MHz ...
fC
fC
fC
fC
±
±
+
Group delay ripple within PB
9,56
10
17,2
360,0
arel
MHz
MHz
MHz
MHz
p-p
Absolute group delay within PB
Phase linearity within PB
p-p
7
Input power level
-
max.
Operable temperature range
-
- 40 °C ... + 85°C
Operating temperature range
OTR
Storage temperature range
Temperature coefficient of frequency
TCf **
-
+25 °C
-
- 45 °C ... + 85°C
-94
ppm/K
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/K) x (T-T0) x fTo(MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140as.doc
Version 1.6
VI TELEFILTER
30.09.2009
Filter specification
TFS 140AS
2/5
0
1.11
-0.6
1.05
-12
-1.2
0.99
-18
-1.8
0.93
-24
-2.4
0.87
-3
0.81
-3.6
0.75
-42
-4.2
0.69
-48
-4.8
0.63
-54
-5.4
0.57
-30
-36
-60
70
84
98
112
126
140
154
frequency in MHz
168
182
196
210
-6
126
128.8
131.6
134.4
137.2
140
142.8
frequency in MHz
145.6
148.4
151.2
delay in µs
0
-6
magnitude in dB
magnitude in dB
Filter characteristic
0.51
154
Construction and pin connection
(All dimensions in mm)
TFS 140AS
U51
●
6,8Max.
13,6Max.
2,54 ±0,15
1,5
2,54 ±0,15
1 2 3 4
2,0Max.
1
12
5
11
6
Date code
10 9 8 7
1
2
3
4
5
6
7
8
9
10
11
12
Ground
Ground
Ground
Ground
Output
Output RF Return
Ground
Ground
Ground
Ground
Input
Input RF Return
Date code:
U
V
W
...
Year + week
2006
2007
2008
0,1
0,8
50 Ohm Test circuit
L1
C1
5
11
12
SAW
6
L2
C2
1,2,3,4,7,8,9,10
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140as.doc
Version 1.6
VI TELEFILTER
30.09.2009
Filter specification
TFS 140AS
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: three times max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
1700
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
P1
Tape (all dimensions in mm)
W
: 24,00 +0,30/-0,10
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,10
F
: 11,50 ± 0,10
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 12,00 ± 0,1
D1(min)
: 1,50
Ao
: 7,10 ± 0,10
Bo
: 13,90 ± 0,10
Ct
: 21,5 ± 0,1
Date Code
Po
Do
P2
W
G
Ct
Bo
F
G
E
t
Ko
Typ
PIN Marker
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 24,4 +2/-0
W2(max) : 30,4
N(min)
: 60
C
: 13,0 +0,5/-0,2
C
A
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140as.doc
Version 1.6
VI TELEFILTER
30.09.2009
Filter specification
TFS 140AS
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 140as.doc
VI TELEFILTER
Version 1.6
Filter specification
30.09.2009
TFS 140AS
5/5
History
Version
Reason of Changes
Name
Date
1.0
- Generation of development specification
Strehl
17.05.2006
1.1
- changed insertion loss Chilla
- changed pass band
- changed relative attenuation
- changed group delay ripple
- introduced absolute group delay
- changed phase linearity
- changed input power level
26.06.2006
1.2
- stopband attenuation updated
Chilla
29.06.2006
1.3
- passband extended
Chilla
06.07.2006
1.4
- changed relative attenuation temporary
- changed group delay ripple
- changed characteristics and passband
Strehl
18.10.2006
1.5
- Created filter specification
- Added terminating impedances
- Added typical values
- Added filter characteristic
- Changed construction
- Added test circuit
- Changed packing
Chilla
21.12.2006
1.6
- Test circuit corrected
Chilla
30.09.2009
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.