TFS468L - Vectron International

Filename: tfs 468l.doc
Version 1.4
Vectron International
12.06.2008
Filter specification
TFS 468L
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
5
°C
dBm
120 Ω || -9 pF
70 Ω || -12 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 468L is the minimum of the pass band attenuation. This value is defined as the insertion loss
ae. The nominal frequency fN is fixed at 468,0 MHz without any tolerance. The values of relative attenuation arel are guaranteed for the whole operating
temperature range. The frequency shift of the filter in the operating temperature range is included in the production tolerance scheme.
Data
typ. value
Insertion loss
(reference level)
ae
Nominal frequency
fN
-
Centre frequency
fC
468
PB
-
Passband
11.3
dB
tolerance / limit
max.
14,0*** dB
468
MHz
MHz
fN
±
9,75
MHz
Pass band ripple
0,3
dB
max.
1,0
dB
Amplitude ripple within fN ± 10,0 MHz
0,2
dB
max.
2,5
dB
23,6
MHz
min.
19,5
MHz
0,3
0,3
17,5
38
46
55
52
dB
dB
dB
dB
dB
dB
dB
max.
max.
min.
min.
min.
min.
min.
1,0
2,5
15
35
40
50
50
dB
dB
dB
dB
dB
dB
dB
Group delay ripple within PB
28
ns
max.
Group delay ripple within fN ± 10,0 MHz
40
ns
max.
1,5
µs
Return loss within fN ± 10,0 MHz
18
dB
min.
8
dB
BW
Bandwidth
1
dB
Relative attenuation
fN
fN
fN
fN
fN
fN
fN
±
±
±
±
+
9,75
15,5
17,0
25,0
438,0
35,0
MHz
MHz
MHz
MHz
MHz
MHz
…
…
…
…
…
…
…
fN
fN
fN
fN
fN
fN
fN
±
±
±
±
±
+
9,75
10,00
17,0
25,0
35,0
35,0
532
arel
MHz
MHz
MHz
MHz
MHz
MHz
MHz
250
Input power level
-
max.
Permissible DC voltage
-
max.
-
- 40 °C ... + 85°C
Operating temperature range
OTR
-
Storage temperature range
Temperature coefficient of frequency
TCf **
-18
ns
15 **** dBm
0
V
- 40 °C ... + 85°C
ppm/K
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/K) x (T-T0) x fcat(MHz).
***) insertion loss at 25°C max. 12,5 dB
****) RF Source Power (peak) is max. 15dBm, RF Source Power (average) is max. 5dBm
Generated:
Checked / Approved:
Vectron International GmbH & Co. KG
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International GmbH & Co. KG reserves the right to make changes to the product(s) and/or information contained herein without
notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such
product(s) or information.
Filename: tfs 468l.doc
Version 1.4
Vectron International
12.06.2008
Filter specification
TFS 468L
2/5
Filter characteristic
0
0
2.29
-0.5
2.08
-1
1.87
-1.5
1.66
-2
1.45
-2.5
1.24
-3
1.03
-3.5
0.82
-4
0.61
magnitude in dB
magnitude in dB
-20
-30
-40
-50
delay in µs
-10
-60
0.4
-4.5
-70
418
428
438
448
458
468
478
frequency in MHz
488
498
508
-5
454
518
456.8
459.6
462.4
465.2
468
470.8
frequency in MHz
473.6
476.4
479.2
0.19
482
Construction and pin connection
(All dimensions in mm)
9
7
6
10
S 468L
● W24
1
4
3
0,6
2,54
1
1,8 +/-0,2
Date code
1
5 ,0 +/-0,2
12
1
2
3
4
5
6
7
8
9
10
11
12
Ground
Ground
Ground
Output
Ground
Output RF Return
Ground
Ground
Ground
Input
Ground
Input RF Return
Date code:
W
X
A
...
Year + week
2008
2009
2010
2,54
7 ,0 +/-0,2
50 Ohm Test circuit
L1
10
12
4
SAW
L2
6
C2
C1
1, 2, 3, 5, 7, 8, 9, 11
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 468l.doc
Version 1.4
Vectron International
12.06.2008
Filter specification
TFS 468L
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: three times max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
P1
Tape (all dimensions in mm)
W
: 16,00 ± 0,3
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,1
F
: 7,50 ± 0,1
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 8,00 ± 0,1
D1(min)
: 1,50
Ao
: 5,50 ± 0,1
Bo
: 7,50 ± 0,1
Ct
: 13,5 ± 0,1
Date Code
Po
Do
P2
W
G
Ct
Bo
F
G
E
t
Ko
Typ
PIN Marker
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 16,4 +2/-0
W2(max) : 22,4
N(min)
: 50
C
: 13,0 +0,5/-0,2
C
A
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 468l.doc
Version 1.4
Vectron International
12.06.2008
Filter specification
TFS 468L
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 468l.doc
Vectron International
Version 1.4
Filter specification
12.06.2008
TFS 468L
5/5
History
Version
Reason of Changes
Name
Date
1.0
- Generation of development specification
Strehl
12.04.2007
1.1
- created filter specification
- added terminating impedances
- added typical values
- added filter characteristic
- added test circuit
Chilla
11.05.2007
1.2
- changed input power level
- changed max. input power level
- changed operating temperature range
- changed relative attenuation
- changed filter characteristic
- tape and reel direction adjusted to Motorola standard
Chilla
15.10.2007
1.3
- tape and reel direction adjusted to Telefilter standard
Strehl
14.01.2008
1.4
- chanded input power level and relative attenuation
- add permissible DC voltage
- loss reduced
Strehl
12.06.2008
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.